Operating Instructions Call Block dedicated Machine Model No. KX-TGA710 KX-TGA760 Thank you for purchasing a Panasonic product. Please read these operating instructions before using the unit and save them for future reference. For assistance, visit our Web site: http://shop.panasonic.com/ support for customers in the U.S.A. Please register your product: http://shop.panasonic.
Table of Contents Introduction Accessory information ...............3 Graphical symbols for use on equipment and their descriptions ...............................4 Important Information For your safety ...........................5 Important safety instructions ......6 For best performance ................6 Other information .......................7 Specifications ............................7 Getting Started Setting up ..................................8 Controls .....................................
Introduction Accessory information Supplied accessories No. Accessory item/Part number A AC adaptor/PNLV226-0X 1 B Telephone line cord/PNJA1210Z 1 A Quantity B Other information R Design and specifications are subject to change without notice. R The illustrations in these instructions may vary slightly from the actual product. For assistance, please visit http://shop.panasonic.
Introduction Graphical symbols for use on equipment and their descriptions Symbol 4 Explanation Symbol Explanation Alternating current (A.C.) Class P equipment (equipment in which protection against electric shock relies on Double Insulation or Reinforced Insulation) Direct current (D.C.
Important Information For your safety To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product. WARNING smoke has stopped emitting and contact us at http:// shop.panasonic.com/support R Unplug from power outlets and never touch the inside of the product if its casing has been broken open. R Never touch the plug with wet hands. Danger of electric shock exists.
Important Information CAUTION Installation and location R Never install telephone wiring during an electrical storm. R Never install telephone line jacks in wet locations unless the jack is specifically designed for wet locations. R Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. R Use caution when installing or modifying telephone lines. R The AC adaptor is used as the main disconnect device.
Important Information R The product should be kept away from heat sources such as heating devices, cooking appliances, etc. It should not be placed in rooms where the temperature is less than 0 °C (32 °F) or greater than 40 °C (104 °F). Damp basements should also be avoided. Notice Routine care R Wipe the outer surface of the product with a soft moist cloth. R Do not use benzine, thinner, or any abrasive powder.
Getting Started 4 Setting up ONE LINE IN PH Connections Connect the AC adaptor to the unit by pressing the plug firmly. Fasten the cord by hooking it. Connect the AC adaptor to the power outlet. Connect the telephone line cord for your external phone to the unit ("LINE IN" port), then to the single-line telephone jack (RJ11C) until you hear a click. A DSL/ADSL filter (not supplied) is required if you have a DSL/ADSL service.
Getting Started oriented AC outlet that faces the floor, such as an AC outlet installed on a ceiling or under a table, as the weight of the adaptor may cause it to become disconnected. Display icons Display items Item The line is in use by your external phone. Controls A Meaning Blocked call (page 12) Allowed call (page 13) B Ringer indicator H C G Status Meaning Green Flashing The call is being received and it matches a phone number stored in the allow list.
Getting Started Language setting You can select either “English” or “Español” as the language used for the following features. – Display – Talking Caller ID announcement The default setting is “English”. 1 2 3 10 MMENUN MbN: “Language” a MOKN MbN: Select the desired setting a MOKN a MEXITN For assistance, please visit http://shop.panasonic.
Basic Operation Caller ID service Important: R This unit is Caller ID compatible. To use Caller ID features, you must subscribe to a Caller ID service. Contact your phone service provider for details. Caller ID features When an outside call is being received, the caller information is displayed. Caller information for the last 50 callers is logged in the caller list from the most recent call to the oldest.
Basic Operation Caller list Viewing the caller list 1 MCALLER LISTN 2 Press MCN to search from the most recent call, or MDN to search from the oldest call. 3 To exit, press MEXITN. Erasing selected caller information 1 MCALLER LISTN 2 MbN: Select the desired entry. 3 MERASEN a MbN: “Yes” a MOKN a MEXITN Call block The unit can block calls: – when receiving the call from the phone number in pre-programmed call block list (14000 items).
Basic Operation Adding call blocked numbers from the caller list 1 MCALLER LISTN 2 MbN: Select the desired entry Viewing/erasing call block numbers 1 MBLOCK LISTN 2 MbN: Select the desired entry. R The number of times the entry was blocked is also displayed. R After viewing, press MEXITN to exit. to be blocked. a MOKN 3 MbN: “Save Block list” a MOKN 4 MbN: “Yes” a MOKN a MEXITN Setting the block mode The unit can block calls by setting the following block mode beforehand.
Basic Operation Adding allowed phone numbers from the caller list 1 MCALLER LISTN 2 MbN: Select the desired entry. aMOKN Viewing/erasing an entry 1 MMENUN 2 MbN: “Allow list” a MOKN 3 MbN: Select the desired entry. After viewing, press MEXITN to exit. 3 MbN: “Save Allow list” a MOKN 4 4 MbN: “Yes” a MOKN a MEXITN Erasing all entries 1 MMENUN 2 MbN: “Allow list” a MOKN Adding allowed phone numbers manually You can also add the phone number in the allow list from your external phone.
Useful Information Error messages Display message Cause/solution Check LINE IN R The telephone line cord has not been connected yet or not connected properly. Check the connections (page 8). Not accepted R Invalid code or character is entered. Try again. Troubleshooting If you still have difficulties after following the instructions in this section, disconnect the AC adaptor, then reconnect the AC adaptor. General use Problem Cause/solution The unit does not work. R Check the connections (page 8).
Useful Information Caller ID/Talking Caller ID Problem Cause/solution Caller information is not displayed. R You must subscribe to Caller ID service. Contact your phone service provider for details. R If your unit is connected to any additional telephone equipment such as a Caller ID box or cordless telephone line jack, plug the unit directly into the wall jack. R If you use a DSL/ADSL service, we recommend connecting a DSL/ADSL filter between the unit and the telephone line jack.
Useful Information Liquid damage Problem Cause/solution Liquid or other form of moisture has entered the unit. R Disconnect the AC adaptor and telephone line cord from the unit. After the unit is completely dry, reconnect the AC adaptor and telephone line cord. If the unit does not work properly, contact an authorized service center. Caution: R To avoid permanent damage, do not use a microwave oven to speed up the drying process. For assistance, please visit http://shop.panasonic.
Useful Information FCC and other information This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US:ACJ----------. If requested, this number must be provided to the telephone company. L Registration No.............(found on the bottom of the unit) L Ringer Equivalence No. (REN).......0.
Useful Information commission for information. If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer. This device complies with Part 15 of the FCC Rules.
Appendix Customer services Shop Accessories! for all your Panasonic gear Go to hp://shop.panasonic.com/support Get everything you need to get the most out of your Panasonic products Accessories & Parts for your Camera, Phone, A/V products, TV, Computers & Networking, Personal Care, Home Appliances, Headphones, Baeries, Backup Chargers & more… Customer Services Directory For Product Informa!on, Opera!ng Assistance, Parts, Owner’s Manuals, Dealer and Service info go to hp://shop.panasonic.
Appendix Limited Warranty (ONLY FOR U.S.A.
Appendix Limited Warranty Limits and Exclusions This warranty ONLY COVERS failures due to defects in materials or workmanship, and DOES NOT COVER normal wear and tear or cosmetic damage.
Index Index A C E T Allow list: 13 Call block: 12 Caller ID service: 11 Caller list: 12 Error messages: 15 Talking Caller ID: 11 Troubleshooting: 15 TTY: 20 23
IMPORTANT! If your product is not working properly. . . 1 Reconnect AC adaptor to the unit. 2 Check if telephone line cord is connected. 3 Read troubleshooting page in the Operating Instructions. Visit our Web site: http://shop.panasonic.com/support LFAQ and troubleshooting hints are available. For your future reference We recommend keeping a record of the following information to assist with any repair under warranty. Serial No.