Specifications

-18-
9.4.Requirement of regarding the end product and manual
End product and literature provided to the end user must include the following wording:
Wording Display location
Contains Transmitter Module
FCC ID:ACJ9TAK-SRB20
IC:216M-KSRB20
User manual and end product
CAN ICES-3(A)/NMB-3(A) User manual and end product
FCC Caution:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
User manual
This device complies with Part 15 of the FCC Rules and Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
User manual and end product.
If it cannot be displayed on
the end product, it must be
displayed on the packaging
box
NOTE: This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
User manual
FCC RF Exposure Warning:
To comply with FCC RF exposure requirements in uncontrolled environment:
− This equipment must be installed and operated in accordance with provided
instructions and a minimum 20 cm (8 inches) spacing must be provided between
antenna and all person’s body (excluding extremities of hands, wrists, feet and ankles)
during wireless modes of operation.
User manual
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
User manual
RSS-Gen
• Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
• This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference.
This device must accept any interference, including interference that may cause
undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d'Innovation, Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :
1. L'appareil ne doit pas produire de brouillage;
L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
User manual