Instruction Manual

 Do not use wireless LAN on airplanes, in hospitals, or in other locations where wireless LAN signals may

affect devices.

Follow the instructions of airline companies and hospitals. If you use the computer in these locations, turn off the

wireless LAN.

 To avoid unauthorized access to the computer through wireless LAN.

We recommend you to make security settings such as encryption before using wireless LAN.

Otherwise the disk data such as the shared files can be exposed to the risk of unauthorized access.

 Communication is established through the wireless LAN antenna (A) and 2nd wireless LAN antenna (B).

Do not block the antenna area with your hand or body.

 When you connect this computer to a port replicator compatible with external antenna, you can switch the

internal antenna to the external antenna, or vice versa.

 The transmission rate will be lower when a microwave oven is used near by.

 To use wireless LAN, set [Wireless LAN]/[Wireless LAN (2nd)] to [Enabled] (default) in the sub-menu of

[Wireless Configuration] in the [Advanced] menu of the Setup Utility.

Using the Wireless LAN Function

Before using a wireless LAN, turn the wireless LAN communication on.

Turning on/off the wireless LAN communication

1. To enable the wireless communication ( Disabling/Enabling Wireless Communication).

Setting the wireless LAN access point

Preparation

Follow the instruction manual of the wireless LAN access point to make settings for the access point to recognize the

computer.

1. Turn the wireless LAN on.

Wireless LAN

IMPORTAN

NOT

PAGE 1
Wireless LAN IMPORTANT  Do not use wireless LAN on airplanes, in hospitals, or in other locations where wireless LAN signals may affect devices. Follow the instructions of airline companies and hospitals. If you use the computer in these locations, turn off the wireless LAN.  To avoid unauthorized access to the computer through wireless LAN. We recommend you to make security settings such as encryption before using wireless LAN.
PAGE 2
. Click 3. Click or on the task tray. at upper of access point displayed, and select then [Wi-Fi 2]. 4. Select an access point, and click [Connect]. 5. Input the key you set for the access point to recognize the computer, and click [Next]. Wait for the computer to connect to the wireless LAN access point. When the icon on the task tray is changed to , the wireless LAN setting is complete. NOTE  The settings depend on the network environment.