Operation Manual

58
Chapter 4 Adjustments and Settings for Recording
 NOTE
This product is preadjusted at the factory to minimize
vertical misalignment.
*
1
The specification for vertical
misalignment is 1.2 % or less.
*
1
It is indicated in percentage of vertical
misalignment between the images from the
left and right lenses at the center of the screen
according to the effective height of the screen,
when measured under the following conditions:
the zoom position at the maximum wide angle
(Z00), the convergence point in the center (C50),
and shooting a subject at a distance of 4.3 m.
Focus (FOCUS)
Press the cursor button  or . The focal length
for the right lens is increased if you press , and is
reduced if you press .
Iris (IRIS)
Press the EXIT (IRIS) or THUMBNAIL (IRIS) button.
The iris of the right lens is opened if you press
EXIT (IRIS), and is closed if you press THUMBNAIL
(IRIS).
 NOTE
• Holding the SET (RESET) button pressed during the 3D FINE
adjustment resets all the adjusted values.
• The 3D FINE function is disabled in 2D LL recording mode.
• The appropriate adjustment area varies depending on the
zoom position. Perform the fine adjustments again if the
zoom position is changed.