TV Converter Box User Manual

Setup menu
14 (E)
REGEN MODE
NORMAL (Default)
24PSync
For selecting the time code conversion method.
NORMAL: Conversion with no synchronization point (head =
00:00:00:00).
24PSync: With the 25 p output, conversion with the designated syn-
chronization point serving as the basic point.
Conditions under which 24PSync TC conversion operates
normally:
Output format: 1080/25P, 720/25P over 59.94P/60P
Time code: CONV
<Note>
The value which was last selected will be used as the setting when
the unit is started up.
AUDIO MUTE
ON
OFF (Default)
For selecting the setting at which the sound is to be muted in the E-E
mode.
ON: The sound is muted.
OFF: The sound is not muted.
SD SUPER
OFF
TC (Default)
TC/UB
For selecting whether the TC and/or UB display is to be superim-
posed onto signals to the SD OUT connector.
OFF: No display.
TC: The time code is displayed.
TC/UB: The time code and user’s bit are displayed.
<Note>
The value which was last selected will be used as the setting when
the unit is started up.
COMP SETUP
OFF
ON (Default)
For selecting whether to set the setup level addition function for the
SD OUT connector.
OFF: The setup is not added.
ON: The setup is added.
<Note>
The value which was last selected will be used as the setting when
the unit is started up.
DOWN CONV
525i (Default)
625i
For setting the SD OUT connector. Depending on the HD output, it
may not be possible to select a setting for this item.
<Note>
The value which was last selected will be used as the setting when
the unit is started up.
ALARM MSG
OFF
ON (Default)
For setting whether to display the alarm screen (see page 19) when
an error has occurred.
OFF: The alarm screen is not displayed.
ON: The alarm screen is displayed.
<Note>
The value which was last selected will be used as the setting when
the unit is started up.
TC REGEN
CONV (Default)
ORG
For selecting the time code which is to be output from the display
panel or RS-422 connector.
CONV: Time code resulting from the conversion of the head or syn-
chronization point as 00:00:00:00.
ORG: Time code during recording.
<Note>
The value which was last selected will be used as the setting when
the unit is started up.
“Default” denotes the factory settings.
Menu item Parameter Description