User Manual

– 21 –
Chapter 2 Description of Parts — Front side, rear side
Front side, rear side
1 1
76
2 3
5
8
4
11109
12
13
14
15
16
17
19
20
21
22
23
18
1 Built-in microphone (page 63)
This is the built-in stereo microphone.
2 Light sensor
Detects indoor and outdoor light.
3 Front tally lamp (page 42)
Lights during shooting. This lamp will blink when the battery level becomes low.
4 Recording button (front side) (page 44)
Press this button to start recording. Press it again to stop recording.
The operation of this button can be forbidden by the main menu → [SW MODE] → [FRONT REC].
5 <AWB> button (page 51)
Press this button to adjust the white balance. Press it for two seconds or more to adjust the white balance and then black balance.
6 Eye sensor (page 41)
Bring your eyes closer to display the screen on the viewnder.
@@
NOTE
t The eye sensor may not work properly depending on the shape of glasses in use, how you hold the camera, or by hitting the strong light around
the eye piece.
t The eye sensor does not work during video playback.
7 Viewnder (page 41)
8 <AUDIO INPUT 1> terminal (XLR, 3-pin) (page 31)
Connect the audio equipment or the microphone.
9 Rear tally lamp (page 42)
Light during shooting. This lamp will blink when the battery level becomes low.
10 Battery attachment (page 27)
11 Battery release button (page 27)
Remove the battery.
12 microP2 memory card 1 access LED (page 35)
Indicate the access status of recording and playback of the card inserted in the microP2 memory card slot 1.
13 microP2 memory card slot 1 (page 34)
14 microP2 memory card 2 access LED (page 35)
Indicate the access status of recording and playback of the card inserted in the microP2 memory card slot 2.
15 microP2 memory card slot 2 (page 34)
16 P2 memory card slot (page 34)
17 P2 memory card access LED (page 35)
Indicate the access status of recording and playback of the card inserted in the P2 memory card slot.
18 <AUDIO OUT> terminal (page 150)
Output audio signals recorded to audio channel 1/2.
19 <USB3.0 HOST> terminal (host) (page 152)
Connect external hard disk drive, etc.
20 <USB2.0 DEVICE> terminal (device) (page 152)
Connect to a computer with the USB 2.0 cable to transfer data.
21 <HDMI OUT> (monitor output) terminal (page 150)
This is the output terminal of the video for monitor.