Multi Purpose Camera Operating Instructions
Table Of Contents
- TABLE OF CONTENTS
- Accessories
- Introduction
- Characteristics
- Precautions for use
- Major operating controls and their functions
- How to install
- How to set up the system
- Configuration example 1: Connection of camera controller
- Configuration example 2: High-speed P/T system (1)
- Configuration example 3: High-speed P/T system (2)
- Configuration example 4: Controlling the camera from the AW-RP655 or AW-RP555 controller
- Control exercised from the AW-CB400.
- When the camera is to be controlled from the AW-RP655 controller
- When the camera is to be controlled from the AW-RP555 controller
- Cable wiring specifications when connecting the camera directly to the AW-CB400, AW-RP655 or AW‑RP555
- Operation procedure
- How to adjust
- Intelligent functions
- Setting of menu items
- Appearance
- Specifications
- 14 -
How to set up the system
Configuration example 1: Connection of camera controller
Use multi cable supplied with AK-HRP150G for the connection of camera controller
AK-HRP150G and this unit.
Multi cable
(POWER + CONTROL)
Lens
Camera controller
AK-HRP150G
AC adapter
AW-PS510AN
Monitor
HD SDI OUT
IRIS
AK-HC1800N
Select “1” as the PROTOCOL
setting.
Before connecting the cables, be sure to set the power switch of AC adapter to OFF.
Connect the multi cable to the interface connector of the camera, and the opposite
side to camera controller.
Set the AC adapter power switch to ON, then the camera can be controlled.
After shooting, set the AC adapter power switch to OFF.