Multi Purpose Camera Operating Instructions
Table Of Contents
- TABLE OF CONTENTS
- Accessories
- Introduction
- Characteristics
- Precautions for use
- Major operating controls and their functions
- How to install
- How to set up the system
- Configuration example 1: Connection of camera controller
- Configuration example 2: High-speed P/T system (1)
- Configuration example 3: High-speed P/T system (2)
- Configuration example 4: Controlling the camera from the AW-RP655 or AW-RP555 controller
- Control exercised from the AW-CB400.
- When the camera is to be controlled from the AW-RP655 controller
- When the camera is to be controlled from the AW-RP555 controller
- Cable wiring specifications when connecting the camera directly to the AW-CB400, AW-RP655 or AW‑RP555
- Operation procedure
- How to adjust
- Intelligent functions
- Setting of menu items
- Appearance
- Specifications
![](/manual/panasonic/ak-hc1800n/multi-purpose-camera-operating-instructions/images/img-25.png)
- 25 -
Black balance adjustment
Adjust it with the lens closed.
When the motor drive lens is controlled from the camera, adjusting the black balance
causes the lens to be automatically closed.
Gen-lock adjustment
When multiple cameras are used or the camera is combined with other equipment, it is
necessary to adjust the phase for phase matching by external synchronization.
Horizontal phase adjustment
Observe the waveforms of externally synchronizing signal input (black burst signal) and
video signal output by a two-phenomenon oscilloscope, and make the horizontal phase
according to the camera menu.
Adjustment with GEN-LOCK of SETTING menu
When HD synchronizing signals are input:
Roughly adjust the synchronizing signal input and video signal output phases by
H PHASE-COARSE.
Finely adjust the synchronizing signal input and video signal output phases by
H PHASE-FINE.
When SD synchronizing signals are input:
Roughly adjust the synchronizing signal input and video signal output phases by
SD-HD PHASE CRS.
Finely adjust the synchronizing signal input and video signal output phases by
SD-HD PHASE FINE. If the adjustment performed using SD-HD PHASE is not
satisfactory, use H PHASE-COARSE/FINE.
How to adjust