User manual
Pan/Tilt Control Panel AW-RP400
22
Introduction
Accessories
≥ This pan/tilt control panel enables up to five AW-PH400
indoor pan/tilt heads to be controlled.
≥ By connecting the AW-CB400 remote operation panel or
WV-CB700A remote control box to the control panel, the
convertible cameras mounted on the pan/tilt heads can be
controlled at the same time.
≥ By installing an additional control panel, two of the five
units in the pan/tilt head system can be controlled at the
same time.
≥ Up to ten tracing memories can be accommodated.
≥ Up to 50 preset memories can be set.
≥ The connection distance between the control panel and
pan/tilt head system can be extended up to a maximum of
500 meters.
NOTE
≥ The AW-RP400 cannot be used to control the model
AW-PH300, AW-PH300A, AW-PH350, AW-PH500 or
AW-PH600 pan/tilt heads.
≥ Before using the control panel, the movement range
(limiters) of the pan/tilt head system must be set
without fail.
≥ When the AW-RP400 control panel is to be discarded
at the end of its service life, ask a specialized
contractor to dispose of it properly in order to protect
the environment.
Zoom switch ................................................................................. 1
Plug (D-SUB 15-pin) for tally/INCOM system ...................... 1 set
Rack-mounting adaptors ............................................................. 2
Mounting screws (M4!8 mm) .................................................... 4