ORDER NO.PTD0408U36C1 F16 Cordless Drill & Driver EY6105-U1 SPECIFICATIONS CONTENTS Page Page 1 SCHEMATIC DIAGRAM 2 4 TROUBLESHOOTING GUIDE 7 2 WIRING CONNECTION DIAGRAM 2 5 EXPLODED VIEW 8 3 DISASSEMBLY/ASSEMBLY INSTRUCTIONS 3 6 REPLACEMENT PARTS LIST 9 © 2004 Matsushita Electric Works Ltd. All rights reserved. Unauthorized copying and distribution is a violation of law.
EY6105-U1 1 SCHEMATIC DIAGRAM 2 WIRING CONNECTION DIAGRAM 2
EY6105-U1 3 DISASSEMBLY/ASSEMBLY INSTRUCTIONS ■HOW TO DISASSEMBLE KEYLESS CHUCK. Ref. No. 1A Procedure 1A Removal of the Keyless Drill Chuck. 1. Set the clutch handle to position and select "LOW" position. 2. Turn the lock collar counterclockwise direction to open the chuck jaws. 3. Use a screwdriver to turn the chuck fastening screw inside the chuck clockwise direction of the arrow, and remove the screw. (See Fig.
EY6105-U1 ■HOW TO DISASSEMBLE MAIN UNIT. Ref. No. 2A Procedure 2A Removal of the Housing. 1. Remove 8 housing screws. (See or Fig.4) Fig.4 Ref. No. 2B Procedure 2A → 2B Removal or attachment of the Motor. (Removal) 1. Take out the motor with the gear box block from housing. 2. Separate the motor from the gear box block by twisting the motor to unlock tabs. (Attachment) 3. Motor mounting base and the positioning rib of gear case should be set. (See Fig.5) Fig.
EY6105-U1 Ref. No. 2C Procedure 2A → 2B → 2C Removal or attachment of the Gear Box Block. (Removal) 1. Turn the thrust plate to remove. 2. The internal parts of gear box block can be removed one after another. (See Fig.6) (Attachment) 1. Start from inserting 6 pins into the driving block as shown in the Fig.7. 2. Assemble the other parts in reverse order as shown in the Fig.6. NOTE : Carrier, Ring Gear, and Ring Gear A have their own correct directions for proper reassembly. 3.
EY6105-U1 Ref.No.2D Procedure 2A → 2B → 2C → 2D Assembly of the Adjusting Screw and the Clutch Handle. 1. Align the mark of adjusting screw with the projection (A) of driving block. 2. Turn the adjusting screw into the driving block about one rotation for clockwise direction. 3. Align the hollow (A) of adjusting screw with the projection (A) of driving block. 4. Set the clutch handle with position 1 on top. (Aligh the position 1 of clutch handle with the projection (A) of driving block.) 5.
EY6105-U1 4 TROUBLESHOOTING GUIDE (Refer to WIRING CONNECTION DIAGRAM) < TROUBLE > Does not operate. < CHECK > → If no less than 12V DC is available across the (+) and (-) terminals, the battery pack is OK. NOTE: The battery pack is sold separately as an optional accessory. See the nearest sales dealer for details. The battery pack has a limited life.
EY6105-U1 5 EXPLODED VIEW 8
EY6105-U1 6 REPLACEMENT PARTS LIST NOTE: *B=only available as set *C=available individually Ref.No. 1 2 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 - Part No.