Operating Instructions - Language - English

Cautions
This product is a class I laser product.
A laser beam leak results in hazardous radiation exposure.
Do not open covers and do not repair it by yourself. Refer servicing to qualified per-
sonnel.
Wave length : 780 nm
Laser power : No hazardous radiation is emitted with safety protection.
Precautions
Volume Level
For your driving safety, keep the volume level low enough to be aware of road and
traffic conditions.
Car Washing
To avoid electrical shorts which may cause fire, or other damage, do not expose
this product (including the speakers and CDs) to water or excessive moisture.
Car Ventilation
If your car is parked for several hours in direct sunlight, the temperature inside the
car may become very high. It is advisable to drive the car and give the interior a
chance to cool down before switching the unit on.
Power Supply
This product is designed to be used in a car having a 12-Volt negative ground bat-
tery system.
Disc Mechanism
Do not insert coins or any small objects. Keep screwdrivers and other metallic
objects away from the disc mechanism and disc.
Service
This product is made of precision parts. Do not attempt to disassemble or adjust
any parts. For repair, please consult your nearest authorized Panasonic Service
Centre.
Note: The preset memory is cleared to return to the original factory setting when the
power connector or battery is disconnected.
Accessories
Something wrong....?!
(Ex. smoke, smell and no sound
B
possibility of fire or shorting.)
q
Turn off the power.
w
Detach the power cord and bring the unit to your dealer.
Product service, repair and enquiry
8 Consult your nearest Panasonic Service Centre.
Trouble Check point
Adjust the balance and fader.
Verify the wiring.
Connect the speaker cord correctly.
3 Sound quality
Left and right
sounds are
reversed
No sound from
left, right, front,
or rear speaker
3 Error indication
CD dirtied
CD upside
down
CD scratched
No operation
by some
cause.
Eject the CD.
Consult your nearest
Panasonic Service
Centre.
Message
Cause Remedy
Troubleshooting
3 General
No sound
Noise
Tune in to another high-intensity station.
Make sure that the antenna mounted point
is grounded properly.
3 Radio
Frequent
noise
Not compatible with MP3/WMA.
Clean the CD.
3 CD Player
Time is counted
but no sound
comes out.
Sound skip,
poor sound
quality
The maximum permissible tilt is 30°.
Secure the unit.
Sound skip
due to vibra-
tion
Never try repair by yourself.
No power
Start the engine. (Or turn the ignition
switch to the ACC position.)
Verify the wiring. (Ex. Battery cord, ACC
cord, grounding cord, etc.)
Fuse blown (Contact the nearest
Panasonic Service Centre.)
Ask a professional for fuse replacement.
Be sure to use the same rated fuse.
Disable the mute function.
Verify the wiring.
Wait until the dew disappears before
turning on the unit.
Make sure that the ground lead is ground-
ed properly.
The preset memory is cleared to return to
the original factory setting when the power
connector or battery is disconnected.
Preset data
deleted
No sound, or
disc is automati-
cally ejected
Load the CD correctly.
Clean the CD.
Trouble Check point
3 CD Player (CONTINUED)
CD not
ejectable
Press [u]. If the CD is not ejected, con-
tact the nearest Panasonic Service
Centre.
CD Player/Receiver
CQ-C1120AN/C1120GN
C1110AN/C1110GN/C1100VN
Operating Instructions
8This operating instruction manual applies to the 5 models below.
The difference among these models are mentioned below.
8All illustrations represent model CQ-C1120AN unless otherwise specified.
Models Face Color
CQ-C1120AN Plating Silver
CQ-C1120GN Plating Silver
CQ-C1110AN Plating Black
CQ-C1110GN Plating Black
CQ-C1100VN Coating Black
Face Illumination Color
Amber
Green
Amber
Green
Blue
Button Illumination Color
Amber
Green
Amber
Green
Red
English
CQ-C1120AN
S
Q
Note: An alarm is generated to remind you of the face plate when turning off the
power.
0AN
Install the face plate
1
2
Release the face plate.
BAND
DISP
]TUNE[
q Slide the left side.
w Press the right side until a “click” is heard.
Take the face plate with you when leaving the car.
Theft Prevention
Remove the face plate
q Pull the right side.
w Slide the left side.
Detach the face plate.
Put the face plate into the case.
Only when “NO CT” appears in the step w below, set the clock.
Clock Setting
Notes on discs
This unit does not support 8 cm discs.
Do not touch the recorded surface.
Avoid leaving CDs in places with direct sunlight, dust and
moisture such as seat and dashboard.
Do not use irregular shaped discs.
You may have trouble playing discs in the following cases.
Dirt, fingerprints, scratches on the disc surface
If a disc is damaged from leaving inside a car for extend-
ed periods, etc.
Inappropriate writing software is used.
Contains other than CD-DA data.
Notes on
CD-R/RW
Not compatible with MP3/WMA.
You may have trouble playing back some CD-R/RW discs
recorded on CD recorders (CD-R/RW drives), either due to
their recording characteristics or dirt, fingerprints, scratch-
es, etc. on the disc surface.
CD-R/RW discs are less resistant to high temperatures and
high humidity than ordinary music CDs. Leaving them
inside a car for extended periods may damage and make
playback impossible.
Some CD-R/RWs can not be played back successfully
thanks to incompatibility among writing software, a CD
recorder (CD-R/RW drive) and the discs.
This player cannot play the CD-R/RW discs if the session is
not closed.
This player cannot play the CD-R/RW discs which contains
other than CD-DA.
Be sure to observe the instructions of CD-R/RW disc for
handling it.
Maintenance
Wipe the unit with a soft dry cloth.
Never apply volatile liquids such as benzine and thinner to
prevent damage.
Fuse
Use fuses of the same specified rating (15A).
Using different substitutes or fuses with higher ratings, or
connecting the unit directly without a fuse, could cause fire
or damage to the unit.
If the fuse replacement fails, contact your nearest
authorized Panasonic Service Centre.
1
2
Thank you very much for purchasing a Panasonic CD Player/Receiver.
Fantastic
Sound Space!
XXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
OO-OOOOO
q
Operating
Instructions
English
(YEFM284127)
Deutsch
(YEFM284128)
Français
(YEFM284129)
Nederlands
(YEFM284130)
Svenska
(YEFM284131)
Italiano
(YEFM284132)
Español
(YEFM284133)
Polski
(YEFM284134)
Q'ty: 1 set
w
Installation
Instructions
English
Deutsch
Français
Nederlands
(YEFM293095)
Svenska
Italiano
Español
Polski
(YEFM293096)
Q'ty: 1 set
e
Warranty Card
Q'ty: 1
r
Removable
Face
Plate Case
(YEFA131646)
Q'ty: 1
t
Mounting
Collar
(YEFX0215873)
Q'ty: 1
y
Power
Connector
(YEAJ02874)
Q'ty: 1
i
Trim Plate
C1100VNL
(YEFC05613)
Others
(YEFC05609)
Q'ty: 1
Press [BAND] to select the
radio AM (MW/LW) mode.
(a Refer to “Radio”)
Press [DISP].
Hold down [DISP] for 2 sec-
onds or more.
Press []TUNE[].
Press [DISP].
Press []TUNE[].
Press [DISP].
(AM mode)
(NO CT)
(Blink: Hours)
Adjust hours
(Blink: Minutes)
Adjust minutes
(Completed)
General
Power Supply : 12 V DC(11 V - 16 V), Test
Voltage 14.4 V, Negative
Ground
Tone Controls (Bass) : ±12 dB at 100 Hz
Tone Controls (Treble) : ±12 dB at 10 kHz
Current Consumption : Less than 2.5 A (CD mode, 0.5
W 4-Speaker)
Maximum Power Output : 45 W x 4 (at 4 )
Power Output : 20 W x 4 (DIN45 324, at 4 )
Speaker Impedance : 4 - 8
Pre-Amp Output Voltage : 2.5 V (CD mode)
Pre-Amp Output Impedance : 200
Dimensions (Main Unit) : 178(W) x 50(H) x 155(D) mm
Weight (Main Unit) : 1.4 kg
CD Player
Sampling Frequency : 8 times oversampling
Pick-Up Type : Astigma 3-beam
Light Source : Semiconductor laser
Wavelength : 780 nm
Frequency Response : 20 Hz - 20 kHz (1 dB)
Signal to Noise Ratio : 96 dB
Total Harmonic Distortion : 0.01 % (1 kHz)
Wow and Flutter : Below measurable limits
Channel Separation : 75 dB
Radio
FM
Frequency Range : 87.5 - 108 MHz
Usable Sensitivity : 6 dB/µV(S/N 30 dB)
Stereo Separation : 35 dB (at 1 kHz)
MW
Frequency Range : 531 - 1 602 kHz
Usable Sensitivity : 28 dB/µV (S/N 20 dB)
LW
Frequency Range : 153 - 279 kHz
Usable Sensitivity : 32 dB/µV (S/N 20 dB)
Specifications
Stereo/Mono Power Amplifier:
CY-M7052EN/CY-M9054EN
(For Upgrade)
CQ-C1120AN/C1120GN/
C1110AN/C1110GN/
C1100VN
Sophisticated Product Achieived by Optional Functions
Sound System with Spurting Realism
(2-channel or 4-channel Power Amplifier)
Powerful Heavy Bass
(Stereo/Mono Power Amplifier) : CY-M7052EN/CY-M9054EN
Subwoofer (For Upgrade)
YEFM284127 ND1203-1014 Printed in China
Matsushita Electric Industrial Co., Ltd.
Web Site : http://www.panasonic.co.jp/global/
Trim Plate Color
Dark Silver
Dark Silver
Dark Silver
Dark Silver
Coating Black
CD-R/CD-RW playable
New simple-setting tone control "SQ" (Sound Quality)
2.5 V preamplifier outputs
18 FM and 6 AM presets with preset scan
Anti-theft system provided by the removable faceplate
ISO Antenna
Adapter
u
Lock Cancel
Plate
Mounting Bolt
Notes:
The number in parenthesis underneath each accessory part name is the part number for
maintenance and service.
Accessories and their parts numbers are subject to modification without prior notice due
to improvements.
Mounting Collar t and Trim Plate i are mounted on the main unit at shipment.
(YEP0FZ3264)
Q'ty: 1 set
Note:
Specifications and design are subject to modifica-
tion without notice due to improvements.
Customer Care Centre
¡ For UK customers: 08705 357357
¡ For Republic of Ireland customers: 01 289 8333
¡ Visit our website for product information
¡ E-mail: customer.care@panasonic.co.uk
Direct Sales at Panasonic UK
¡ Order accessory and consumable items for your product
with ease and confidence by phoning our Customer Care
Centre Monday - Friday 9:00am - 5:30pm. (Excluding
public holidays).
¡ Or go on line through our Internet Accessory ordering
application at www.panasonic.co.uk.
¡ Most major credit and debit cards accepted.
¡ All enquiries transactions and distribution facilities are
provided directly by Panasonic UK Ltd.
¡ It couldn't be simpler!
¡ Also available through our Internet is direct shopping for
a wide range of finished products, take a browse on our
website for further details.
Sales and Support Information

Summary of content (2 pages)