Operating Instructions - Language - English

15
CQ-C1400N/1300AN/1300GN
6
E
N
G
L
I
S
H
14
CQ-C1400N/1300AN/1300GN
5
E
N
G
L
I
S
H
q
Radio Mode
Press [SRC] (Source) to select the radio mode.
Radio Mode Display
w
Band
Press [BAND].
e
Tuning
[[] : Higher frequency
[]] : Lower frequency
Press and hold [[] or []] for more than 0.5
seconds, then release. Seeking will start.
r
Mono/Local Selection
MONO : Monaural reception. Select MONO to
reduce noise when receiving a weak
stereo broadcast.
LOCAL :Only stations with good reception are
detected in seek tuning.
FM broadcasts
Press and hold [PTY] (MONO/LOC) to change
the mode. Release when at the desired point.
AM broadcast
Press [PTY] (MONO/LOC) to switch LOCAL
mode on and off.
MONO/LOCAL indicator
Example: MONO ON/LOCAL ON
Radio
FM1
FM2
FM3
AM (LW/MW)
[SRC] (Source)
[BAND] (APM: Auto Preset Memory)
Preset buttons [1] to [6]
(Preset Station)
[]][[]
(Tune)
Preset number
Band
Frequency
AM broadcastFM broadcast
MONO OFF
LOCAL OFF
MONO ON
LOCAL OFF
MONO ON
LOCAL ON
MONO OFF
LOCAL ON
LOCAL ON
LOCAL OFF
[PTY] (MONO/LOC)
lights
(Default)
(Default)
(Default)
Station Preset
Up to 6 stations can be stored in each of the FM1, FM2, FM3 and AM (LW/MW) band selections.
Caution:
¡ To ensure safety, never attempt to preset stations while you are driving.
Note:
¡ New stations overwrite existing saved stations after following this procedure.
Preset Station Calling
q Select a band. (a Previous page)
w Press one of the preset button from [1] to [6].
Auto Preset Memory (APM)
Automatically save stations with good reception in the pre-
set memory.
q Select a band. (a Previous page)
w Press and hold [BAND] (APM: Auto Preset Memory)
for more than 2 seconds.
The 6 stations with good reception will be automatically
saved in the memory under preset number 1 to 6.
Once set, the preset stations are sequentially scanned
for 5 seconds each. (scanning)
Note:
¡ To stop the scanning, press one of the buttons from [1]
to [6].
¡ Only RDS stations will be saved at default setting (AF
ON). To select non RDS stations too, set AF
OFF. (a Page 17)
Manual Preset Memory
Manually save a station in preset memory.
q Select a band and frequency. (a Previous page)
w Press and hold one of the preset buttons from [1] to [6]
until the display blinks once.