Operating instructions
28
CQ-C5400/5300/5100W
CQ-C5400/5300/5100W
29
Station Preset
Up to 6 stations can be stored in each of the FM1,
FM2, FM3 and AM band selections.
Auto Preset Memory (APM)
Automatically save stations with good reception in
the preset memory.
1 Select a band (previous page).
2 Press and hold [BAND] (APM: Auto Preset
Memory) for more than 2 seconds.
≥ The 6 stations with good reception will be
automatically saved in the memory under
preset number 1 to 6.
≥ Once set, the preset stations are sequentially
scanned for 5 seconds each (scanning).
Manual Preset Memory
Manually save a station in the preset memory.
1 Select a band and frequency (previous page).
2 Press and hold one of the buttons from [1] to [6]
until the display blinks once.
Note:
≥ To stop scanning, press one of the buttons from
[1] to [6].
≥ New stations overwrite existing saved stations
after this procedure.
Preset Station Calling
1 Select a band (previous page).
2 Press one of the preset buttons from [1] to [6].
Radio
Direct Memory (D·M)
This is a useful function that can call broadcast
stations directly during playback in other modes (CD,
CD Changer, etc.), even when the power is off.
Your favorite radio station can be memorized in
[D·M] (direct memory).
Default: FM 87.50 MHz
∫ Memorize
1 Select a band and frequency.
2 Press and hold [D·M] for more than 2 seconds.
≥ Frequency is saved in the memory.
Note:
≥ New stations overwrite existing saved stations
after following this procedure.
∫ Recalling the Direct Memory
Press [D·M].
Direct Memory mode
Press [D·M] again to cancel.
[%] [$] (TUNE)
Caution:
≥ To ensure safety, never attempt to preset
stations while you are driving.
[D·M] (Direct Memory)
E
N
G
L
I
S
H
5
E
N
G
L
I
S
H
6
Preset buttons [1] to [6]
(Preset station)
[BAND]
(APM: Auto Preset Memory)
Display Change
Press [DISP] (display).
[SOURCE]
(Stereo) indicator
Radio Mode
Press [SOURCE] to select the radio mode.
Radio mode display
1
Band
Press [BAND].
2
Tuning
[$]: Higher frequency
[%]: Lower frequency
Press and hold [%] or [$] for more than
0.5 seconds, then release. Seeking will start.
3
Radio mode display
(default)
Clock display
Preset number
[DISP]
(Display)
FrequencyBand
Display off