Operating Instructions

CQ-C7305N
Radio
English
19
Up to 6 stations can be preset in AM (LW/MW), FM1,
FM2, and FM3 respectively.
Preset stations can be simply called up by pressing [}]
(P-SET) or [{] (P-SET).
Notes:
¡ Direct selection can be executed with [1] to [6] but-
tons on remote control.
¡ You can switch between 6 and 18 for FM presetting
stations. (EACH BAND/ALL BAND)
Auto Preset Memory (APM)
Stations with good receiving conditions automatically
preset.
1
Select a band.
2
Hold down
[BAND] (APM)
for 2 sec. or
more.
The preset stations under best receiving conditions
are received for 5 sec. each after presetting the sta-
tions (SCAN). To stop scanning, press [}] or [{].
Notes:
¡ New stations overwrite existing saved stations.
¡
Only RDS stations will be saved at default setting (AF ON).
To select non RDS stations too, set AF/TA OFF. (a page 21)
Manual station preset
1
Tune in to a station.
2
Hold down [}] or [{] for 2 sec. or
more.
3
Turn [VOL] to select a preset number.
4
Hold down [PUSH SEL] for 2 sec. or
more, and the frequency is stored at the
selected preset number.
Notes:
¡ In step 2, a station can be registered by holding down
the numeric button [1] to [6] for 2 sec. or more.
¡ To stop presetting stations, press [DISP:
DISPLAY ].
¡ The operation above allows users to replace the cur-
rent station with the station preset in the selected
number while selecting a preset station. (Preset Swap)
Station Preset
(APM: AUTO PRESET MEMORY P-SET: PRESET)
Radio Menu Display
Only LOCAL is available while receiving an AM station.
1
Press [MENU] to display the menu dis-
play.
For using the remote
control, hold down
[SEL] (MENU) for 2
sec. or more.
2
Turn [VOL] to select a function to be
adjusted.
For using the remote
control, use [}] or
[{].
3
Press [PUSH SEL] to adjust.
For using the remote control, use [BAND] (SET).
4
Press [MENU] to close the menu
screen.
For using the remote control, hold down [SEL]
(MENU) for 2 sec. or more.
MONO (Monaural)
Noise reduction when the signal strength decreases
: Receiving in stereo (default)
: Receiving in mono and reducing the noise level
LOCAL
Setting when searching for a station
: Searching even for a relatively low-intensity radio
wave station (default)
: Searching only for a high-intensity radio wave
station
PRESET
Preset range for FM bands
: Setting of FM1–3 together (default)
: Individual setting for FM1–3 each
C7305N_OI_01_eng.qxd 06.11.14 8:41 AM ページ19