Operating instructions

ManualsBrandsPanasonic ManualsCD-playersCQDFX972U

CQ-DFX972U

General

CQ-DFX972U

Before Reading these Instructions

You can operate this unit by pressing buttons on the main unit and the remote control unit.

∫ These instructions describe buttons that are concerned with operations as follows.

Example: Press [P·SET "] or [P·SET #]/["] or [#].

∫ Some operations can be activated by pressing buttons only on main unit or remote control unit.

Those cases are described in the instructions.

Example: Press [OPEN] on the main unit.

Battery Installation

1 Remove the battery holder.

Pull the battery holder by the position B while pushing

position A in the direction indicated by the arrow.

2 Install the battery on the battery holder.

Set a new battery properly with its “i” side facing up

as shown in the ﬁgure.

3 Insert the battery holder.

Push the battery holder back into its original position.

Battery Notes

Remove and dispose of an old battery immediately.

Battery Information:

≥ Battery type: Panasonic lithium battery (CR2025) (included)

≥ Battery life: Approximately 6 months with normal use (at room temperature)

≥ Do not disassemble or short the battery. Do not throw a battery into a ﬁre.

≥ Keep batteries away from children to avoid the risk of accidents.

≥ Be careful to observe proper local disposal rules when you dispose of batteries.

Caution:

≥ Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a ﬁre.

Battery leakage may damage the unit.

[buttons on the main unit]/[remote control unit]

Point the remote control unit at the main unit’s sensor.

Remote Control Unit Preparation

Lithium battery

(included)

Back side

Position B

Position ABattery holder

Note:

≥ When the power is switched on for the

ﬁrst time, a demonstration message ap-

pears on the display.

To cancel this display, press [DISP] (dis-

play).

Power

Turn the key in the ignition until the accessory in-

dicator lights.

ON: Press [SRC] (PWR)/[SOURCE] (POWER).

OFF: Press and hold [SRC] (PWR)/[SOURCE]

(POWER) again for more than 1 second.

≥ After turning off the ignition key, a security

message is displayed, and the panel removable

alarm that reminds you to take the panel is acti-

vated.

(When security function is set to on ➡ page 40)

Radio

CD player

CD changer control

AUX-IN setting

(When a CD is in the player.)

MP3 player

(When a MP3 ﬁle recorded disc

in the player.) (➡ page 27)

(When a CD changer is connect-

ed and magazine is in the

changer.) (➡ page 32)

SRC

DISP

SET/DISC

CQ-DFX972U

;

/ 1

OPEN

BAND

TUNE

TRACK

CD RECEIVER WITH FULL DOT MATRIX DISPLAY

FOLDER

SET/APM

VOLUM

SOURCE

T E X T

MOSFET

50W

Car Audio

SOURCE

MUTE

POWER

RAND

VOL

312

DISPBAND

REP

SET

SEL

SCAN

NUMBER

[SOURCE]

(POWER)

[DISP]

(Display)

Remote control signal sensor

Source

Press [SRC] (SOURCE)/[SOURCE] to change the source.

Summary of content (10 pages)

PAGE 1
E N G L I S H Before Reading these Instructions General You can operate this unit by pressing buttons on the main unit and the remote control unit. 1 ∫ These instructions describe buttons that are concerned with operations as follows. Example: Press [P·SET "] or [P·SET #]/["] or [#]. 1 Power Turn the key in the ignition until the accessory in- E N G L I S H 2 dicator lights. ON: Press [SRC] (PWR)/[SOURCE] (POWER). OFF: Press and hold [SRC] (PWR)/[SOURCE] (POWER) again for more than 1 second.
PAGE 2
E N G L I S H General (Continued) 3 On the main unit: Turn [VOLUME] dial Clockwise: Up Counterclockwise: Down Volume E N G L I S H Display Change 4 M EN U When Power is ON PUSH Press [DISP] (display). Down VO Mode display The title information can be displayed in CD player or MP3 player mode. (➡ pages 22, 27) Open/Close the Front Panel Up LU ME OPEN: Press [OPEN] on the front panel. CLOSE: Raise the panel by hand.
PAGE 3
Radio E N G L I S H Mode 1 Radio Press [SRC] (SOURCE)/[SOURCE] to change to 5 Caution: ≥ To ensure safety, never attempt to preset stations while you are driving. the radio mode. E N G L I S H One-Touch Selection of a Preset Station 6 Up to 6 stations each can be saved in the FM1, FM2, FM3 and AM preset station memories. 1 Select a band and frequency (steps 1, 2 and 3 on the previous [P·SET "] [P·SET #] (Preset station/select) page).
PAGE 4
CD Player E N G L I S H Disc Insert and Playback Caution: ≥ Only 5z (12 cm) CD, CD-DA data recorded CD-R and CD-RW discs, MP3 data recorded CD media (CDROM, CD-R, CD-RW) are available for this unit. ≥ If a disc contains both CD-DA and MP3 data, only one type of data will be played back. For example, if the disc starts with CD-DA data, it will be recognized as an ordinary music CD, if it starts with an MP3 file, it will be recognized as an MP3. ≥ Refer to page 51 about notes on CD-Rs/RWs.
PAGE 5
CD Player (Continued) E N G L I S H Note: ≥ Operations except setting should be performed after returning to the mode display. ≥ Press [MENU], [DISP] (display) to return to the regular mode. Menu Setting on CD Player Mode 9 [MENU] [P·SET #] [P·SET "] (Submenu) [DISP] (Display) [BAND] (Setting) CQ-DFX972U MUTE DISP E N G L I S H 10 OPEN MOSFET 50W X 4 P.
PAGE 6
MP3 Player E N G L I S H Caution: ≥ Only 5z (12 cm) CD, CD-DA data recorded CD-R and CD-RW discs, MP3 data recorded CD media (CDROM, CD-R, CD-RW) are available for this unit. ≥ If a disc contains both CD-DA and MP3 data, only one type of data will be played back. For example, if the disc starts with CD-DA data, it will be recognized as an ordinary music CD, but it starts with an MP3 file, it will be recognized as an MP3. ≥ Refer to page 51 about notes on CD-Rs/RWs. ≥ Refer to page 42 about notes on MP3.
PAGE 7
MP3 Player (Continued) E N G L I S H Direct MP3 Folder Selection Listening to a MP3 Data Only for the remote control unit Example: folder number 10 1 Press [„] (NUMBER). 13 Player Mode 1 MP3 (When a MP3 files recorded disc is in the player.) Press [SRC] (SOURCE)/[SOURCE] to change to MP3 player mode. Playback will start automatically. 2 Press [1] [0]. [BAND] (;/1) (Pause) CQ-DFX972U MUTE DISP OPEN MOSFET 50W X 4 P.
PAGE 8
MP3 Player (Continued) E N G L I S H Note: ≥ Operations except setting should be performed after returning to the mode display. ≥ Press [MENU], [DISP] (display) to return to the regular mode. Menu Setting on MP3 Player Mode 15 [MENU] [P·SET #] [P·SET "] (Submenu) [DISP] (Display) [BAND] (Setting) CQ-DFX972U MUTE DISP MOSFET 50W X 4 E N G L I S H 16 OPEN P.
PAGE 9
CD Changer Control E N G L I S H 17 CD changer functions are designed for optional Panasonic CD changer unit. Preparation: ≥ Connect the CD changer, and load a magazine (disc). Note: ≥ Loading a magazine when the power is off allows the power to be turned on. ≥ Ejecting the magazine when the unit is in the CD changer mode allows the power to be turned off. ≥ This unit does not support CD-ROM, CD-R, or CD-RW playback through the CD changer. Use the CD changer to listen to normal music CD exclusively.
PAGE 10
CD Changer Control (Continued) E N G L I S H Note: ≥ Operations except setting should be performed after returning to the mode display. ≥ Press [MENU], [DISP] (display) to return to the regular mode. Menu Setting on CD Changer Mode 19 [MENU] [P·SET #] [P·SET "] (Submenu) [DISP] (Display) [BAND] (Setting) CQ-DFX972U MUTE DISP E N G L I S H 20 OPEN MOSFET 50W X 4 P.