Operating instructions

45
CQ-VX1300W
1
E
N
G
L
I
S
H
44
CQ-VX1300W
31
E
N
G
L
I
S
H
32
Time is counted but no
sound comes out.
■ CD (continued)
Trouble Cause/Step
When the first track contains other than CD-DA data, silent playback continues
for a while.
aSelect the next track.
High tones are improp-
erly emphasized.
Reproduction of high
tones is poor.
Wow and flutter level
is very high.
Trouble Cause/Step
Tape running mechanism is dirty or out of order.
aClean tape running mechanism, or repair it. (Ask a service representative
for advice.)
Heads are magnetized.
aDemagnetize heads. (Ask a service representative for advice.)
Normal type tape plays with Metal mode.
aChange Metal mode to Normal mode.
Non-Dolby B NR tape plays with Dolby B NR on.
aSet Dolby B NR to OFF.
Metal type tape plays with normal mode.
aChange Normal mode to Metal mode.
Dolby B NR tape plays with Dolby B NR off.
aSet Dolby B NR to ON.
Poor quality tape.
aUse better quality tape.
Heads are dirty.
aClean heads. (Ask a service representative for advice.)
Blank tape is inserted in the unit.
aInsert recorded tape into the unit.
No sound.
Tape sound quality is
poor.
■ Cassette Tape
Troubleshooting(continued)
Trouble Cause/Step
Battery cable is not correctly connected.
aConnect the battery cable to the terminal that is always live.
aCheck that the antenna was installed and grounded properly.
Station is too far, or signals are too weak.
aSelect other stations of higher signal level.
Too much noise in FM
stereo and monaural
broadcasts.
Preset station is reset.
■ Radio
Trouble Cause/Step
¡Disc is defective.
¡Mechanical trouble.
a Press [u] (EJECT). If normal operation is not restored, please consult the
shop where you purchased the unit.
Unstable mounting.
aMount the unit securely with the mounting parts, referring to the section
on Installation (
a page 38).
Mounting angle is over 30°.
a Adjust mounting angle to less than 30° (a page 38).
aSome CD-R/RWs can not be played back successfully due to
incompatibility among writing software, a CD recorder (CD-R/RW drive)
and the discs. Refer to instructions for the concerned devices for details.
Disc is dirty.
a Clean disc, referring to the section on “Notes on Discs” (a page 48).
aSome CD-R/RWs can not be played back successfully due to
incompatibility among writing software, a CD recorder (CD-R/RW drive)
and the discs. Refer to instructions for the concerned devices for details.
A disc that has data other than CD-DA type is loaded.
a Discs that have CD-DA type data should be used.
Disc is dirty.
a Clean disc, referring to the section on “Notes on Discs” (a page 48)
Disc is upside down.
a Place disc in the correct direction with the label side up.
Disc is in the CD
compartment but no
sound is heard, or disc
is ejected automatically.
Sound skips, bad
sound quality. (e.g.
caused by noise)
Sound skip due to
vibration.
Disc is not ejected.
■ CD