Operating Instructions
6
ECONAVI
To optimise energy saving
MODE
To select operation mode
HEAT - To enjoy warm air
COOL - To enjoy cool air
DRY - To dehumidify the environment
FAN - To circulate air in the room
AUTO - For your convenience
+8/10°C
HEAT
To use maintenance heating
•
Maintain indoor temperature at 8/10°C. Fan
switches to high fan speed automatically.
•
This operation overwrite the operation mode and
could be cancelled by pressing
MODE
.
• Defrost operation at outdoor unit
will result in sudden cold air from
indoor unit. Eliminate cold air with
heat mode.
POWERFUL/
QUIET
To switch between
powerful & quiet
QUIETPOWERFUL NORMAL
POWERFUL: To reach temperature quickly
POWERFUL
•
This operation stops automatically after 20
minutes.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
How to use
Auto OFF/ON button
AUTO
OFF/ON
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
1. Press the button once to use in AUTO mode.
2. Press and hold the button until you hear 1 beep, then release to use in forced
COOL mode.
3. Repeat step 2. Press and hold the button until you hear 2 beeps, then release to
use in normal COOL mode.
4. Repeat step 3. Press and hold the button until you hear 3 beeps, then release to
use in forced HEAT mode.
• Press the button again to turn off.
Sunlight sensor and
remote control receiver
Indicator
TIMER
+8/10°C HEAT
NANOE-G
POWERFUL
QUIET
POWER/
DEICE
(Green/Blue) (Green) (Blue) (Orange)(Orange)(Orange) (Green)
FAN SPEED
To select fan speed
(Remote control display)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
• In HEAT mode, if manual fan speed caused
discomfort, set the fan speed to AUTO or lower
the fan speed.
MODE
POWERFUL/
QUIET
TEMP
OFF/ON
TIMER
SET
CANCEL
ON
OFF
1
2
3
AIR SWING
FAN SPEED
+8/10°C
HEAT
SET CHECK CLOCK RESET
AC
RC
FAN
SPEED
AIR
SWING
ECONAVI
NANOE-G
+8/10°C
HEAT
AUTO
HEAT
COOL
DRY
FAN
/
TEMP
OFF/ON
TIMER
S
ET
C
AN
C
E
L
ON
O
FF
1
2
3
C
HE
CK
CL
O
C
K
Remote control
display
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
Not used in normal
operations.
10˚C
8˚C