User's Manual

311
11. Connecting to other devices
1 Press 3 to select the multiple printing setting in step 3 of “Printing the
Pictures”. (P310)
2 Press 3/4 to select an item and then press [MENU/SET].
3 Press 3/4 to select [Print start] and then press [MENU/SET].
Selecting multiple pictures and printing them
[Multi Select]
Multiple pictures are printed at one time.
•Press 3/4/2/1 to select the pictures and then press [MENU/
SET].
(Press [MENU/SET] again to cancel the setting.)
• After the pictures have been selected, press [DISP.].
[Select All] Prints all the stored pictures.
[Rating] Prints all images with [Rating] levels between [¿1] and [¿5].
• Group pictures will not be displayed as group pictures but as single pictures.
• Disconnect the USB connection cable after printing.
• Use a sufficiently charged battery or an AC adaptor (optional) and DC coupler (optional). If the
remaining battery power becomes low while the camera and the printer are connected, the
alarm beeps. If this happens during printing, stop printing at once. If not printing, disconnect
the USB connection cable.
• Before removing or inserting the card, turn off the camera and disconnect the USB connection
cable. Otherwise, damage may be caused to the recorded data.
• Some printers can print directly from the card removed from the camera. For details, refer to
the operating instructions of your printer.
• The camera is receiving an error message from the printer when the [¥] indication lights
yellow during printing. After finishing printing, make sure there are no problems with the
printer.
• If the number of prints is high, the pictures may be printed several times. In this case, the
remaining number of prints indicated may differ from the number set.
• When you print RAW images, JPEG images that were recorded at the same time will be
printed. If JPEG images were not recorded, printing is not possible.
Not available in these cases:
• Motion pictures, 4K burst files, and images recorded with the Post Focus function cannot be
printed.