User Manual

4. Focus, Brightness (Exposure) and Color tone Settings

∫ Displaying the AF area position in the magnification window (AF Point Scope)

You can temporarily display the magnification window to check the AF area position and

focus.

• When using the [ ] or [ ] mode or a mode such as [ ] ([Custom Multi]), the center area of

the screen will be displayed in the magnification window.

Press and hold [Fn4] while the recording screen is

displayed.

• The Focus Mode will change to [AFS].

When you press the shutter button halfway, the focus will be

readjusted with a smaller AF area.

• You can rotate the front/rear dial to adjust the magnification

factor.

: Magnifies/reduces the window in small steps

: Magnifies/reduces the window in large steps

• The AF area position and the magnification window position cannot be changed.

Setting the methods for displaying the magnification window

> [Custom] > [Focus / Release Shutter] > [AF-Point Scope

Setting]

[Keep Enlarged

Display]

[ON]: Displays/hides the magnification window each time the appropriate

function button is pressed.

[OFF]: Displays the magnification window while the appropriate function

button is pressed and held.

[PIP Display]

[FULL]: Displays the window in full screen mode.

[PIP]: Displays the window in windowed mode.

• If the ambient temperature is high or AF Point Scope is used continuously, after [ ] is

displayed, the magnification window may be disabled to protect the camera. Wait until the

camera cools down.

• In windowed mode, you can magnify the window by approximately 3k to 6k; in full screen

mode, you can magnify the window by approximately 3k to 10k.

Not available in these cases:

• This function is not available in the following cases:

– [Miniature Effect] (Creative Control Mode)

– When recording motion pictures

– When recording in Burst Mode

(only when [Burst Shot Setting] is set to [SH2]/[SH1]/[SH2 PRE]/[SH1 PRE])

– When recording 6K/4K photos

– When recording with the Post Focus function

– When [4K Live Cropping] is set

– When recording in [Multi Exp.]

– When using the Digital Zoom