User Manual

69
Recording mode
Taking pictures after automatically setting the
aperture value and shutter speed
(Program AE Mode)
Recording mode:
Take pictures using automatic aperture values and shutter speed settings in accordance
with the brightness of a subject.
1
Set mode dial to [ ]
2
Press the shutter button halfway
• If the aperture value and shutter speed flash red, you do not have the correct
exposure.
3
While the numeric values are displayed
(approximately 10 seconds), rotate the
rear or front dial to change the values
using Program Shift
Program Shift indication
Aperture value
Shutter speed
8.05.64.0
250 125 60 30 15
60
p
• It will switch between Program Shift operation and Exposure Compensation
operation (→112) every time the rear dial is pressed while the values are
displayed (only when [Exposure Dial] (→49) is set to [OFF]).
• To cancel Program Shift, either turn off the camera or rotate the rear or front dial
until the Program Shift indication turns off.
• Program Shift can easily be canceled by setting a function button to [One Push
AE]. (→60, 75)
About Program Shift
The function for maintaining the same exposure (brightness) while changing the aperture
value and shutter speed combination is called “Program Shift”. You can use “Program
Shift” to take pictures by adjusting the aperture value and shutter speed even in Program
AE Mode.
●
Program Shift cannot be used in the following cases:
• When recording using the flash
• When recording 4K photos
• When recording using [Post Focus]
• When ISO sensitivity is set to [
]