Operating Instructions

357
12. Others
• Stripes may appear in high ISO sensitivity or depending on the lens you use.
> Decrease the ISO sensitivity. (P108)
• When recording under fluorescent or LED lighting fixture, etc., increasing the shutter speed
may introduce slight changes to brightness and colour. These are a result of the characteristics
of the light source and do not indicate a malfunction.
• When recording subjects in extremely bright locations or recording under fluorescent lighting,
LED lighting fixture, mercury lamp, sodium lighting, etc., the colours and screen brightness may
change or horizontal striping may appear on the screen.
• There may be defective pixels in the image sensor.
> Perform [Pixel Refresh] (P264).
• If you continue to use the same card after changing [System Frequency] (P259), motion
pictures may not be recorded. To record with the same card, reset [System Frequency] to the
original setting. To record motion pictures with the current setting, try the following:
– Perform formatting (P30) on this unit after saving necessary data on a PC, etc.
– Insert a different card.
• You may not be able to record for a short while after turning this unit on when using a large
capacity card.
• If the ambient temperature is high or a motion picture is recorded continuously, or depending on
the card used, after [ ] is displayed, recording may stop to protect the camera. Wait until the
camera cools down.
• Depending on the [Rec Format] and [Rec Quality] of a motion picture, the speed class rating
required for the card differs. Use a card that meets the rating. (P28)
Stripes appear in high ISO sensitivity.
The brightness or the hue of the recorded picture is different from the actual
scene.
Bright spot not in subject is recorded.
Motion pictures
Recording motion pictures is not possible.
Motion picture recording stops in the middle.