Operating Instructions
Connecting to Other Devices – Printing
699
• If [USB Mode] is set to [PictBridge(PTP)] in the [Setup] ([IN/OUT]) menu, the
camera will be automatically connected to the printer without the [USB Mode]
selection screen being displayed. (Î[USB Mode]: 601)
• Take care not to turn off the camera while printing is in progress.
• When connecting with the printer is not possible, set [USB Power Supply] to
[OFF] and then try connecting again. (Î[USB Power Supply]: 601)
• Do not disconnect the USB connection cable while [ ] (Cable disconnect
prohibit icon) is displayed.
• Disconnect the USB connection cable after printing.
• Turn off the camera and disconnect the USB connection cable before removing
the card from the camera. Otherwise, the recorded data may be damaged.
• To print images with paper size and layout settings not supported by the camera,
set the [Paper Size] and [Page Layout] to [ ] and then select the desired
settings on the printer.
(For details, refer to the operating instructions for your printer.)
• If a yellow [¥] is displayed, the camera is receiving an error message from the
printer. Check that there is no problem with the printer.
• If the number of prints is high, the pictures may be printed in batches. In this
case, the remaining number of prints indicated may differ from the number set.
• RAW images cannot be printed.
• Images recorded with the following function cannot be printed:
– Video recording