S P E C F I L E The PT-D5700L is not equipped with a lens. P ro d u c t N u m b e r : PT-D5700/D5700L P ro d u c t N a m e : DLP ™ Projectors As of January 2009. Specifications subject to change without notice.
S P E C F I L E PT-D5700/D5700L DLP ™ Projectors Specifications Main Unit Power supply: Power consumption: DLP™ chip: Lens: North America: Europe: North America: Europe: Panel size: Display method: Pixels: PT-D5700: PT-D5700L: Lamp: Screen size: Brightness* 1 : Center-to-corner uniformity* 1 : Contrast* 1 : Resolution: Scanning frequency: RGB: YPBPR (YCBCR): S-Video/Video: Optical axis shift: Keystone correction range: Installation: Terminals* 2 : DVI-D IN: RGB 1 IN: R, G, B: Y, PB, PR: RGB 2
S P E C F I L E PT-D5700/D5700L DLP ™ Projectors On-screen menu: Dimensions (W x H x D): PT-D5700 PT-D5700L Weight* 3 : PT-D5700 PT-D5700L Operating temperature: Operating humidity: Remote Control Unit Power supply: Operation range* 4 : Dimensions (W x H x D): Weight: Supplied Accessories Optional Accessories Replacement lamp unit: Ceiling mount bracket: Zoom lens (1.3–1.8:1) Zoom lens (2.4–4.0:1) Zoom lens (3.4–4.4:1) Zoom lens (4.5–8.4:1) Fixed-focus lens (0.8:1) Zoom lens (1.3 –2.
S P E F C I L E PT-D5700/D5700L DLP ™ Projectors Dimensions 478.5 (18-27/32) 441 (17-3/8) 368 (14-1/2) 4 (5/32) 12 (15/32) 157 (6-3/16) 167 (6-9/16) 86.5 (3-13/32) 425 (16-23/32) 0 16) R3 -3/ (1 unit : mm (inch) NOTE: This illustration is not drawn to scale. The illustration shows the PT-D5700.
P E C F I L E PT-D5700/D5700L DLP ™ Projectors (when installed using the ET-PKD56H) 340–420 (13-3/8˝– 16-17/32˝) Standard setting-up position H Upper edge of projected image *2 417–497 (16-13/32˝– 19-9/16˝) S L *1 Projected image 256 (10-3/32˝) *1 When the lens protrudes to the maximum.
S P E F C I L E PT-D5700/D5700L DLP ™ Projectors Projection distance for 4:3 aspect ratio screen: ET-DLE100/DLE200/DLE310/DLE410/DLE050 Unit: millimeters Screen size (inch, diagonal) Distance to screen (L) Zoom Fixed-focus Height from the edge of screen to center of lens (H) Zoom lenses Fixedfocus lens ET-DLE100 Zoom lens ET-DLE200 Zoom lens ET-DLE310 Zoom lens ET-DLE410 Zoom lens min. max. min. min. max. min. max. ET-DLE050 Fixed-focus lens 794 0 – 381 381 max.
S P E C F I L E PT-D5700/D5700L DLP ™ Projectors Projection distance for 4:3 aspect ratio screen: Supplied lens and ET-DLE150/DLE250/DLE350/DLE450/DLE055 Unit: millimeters Screen size (inch, diagonal) Distance to screen (L) Zoom Fixed-focus ET-DLE150 Zoom lens Supplied lens ET-DLE250 Zoom lens ET-DLE350 Zoom lens ET-DLE450 Zoom lens min. max. min. max. min. max. min. max. min.
S P E C F I L E PT-D5700/D5700L DLP ™ Projectors Calculation of the projection distance For a screen size different from the above, use the equation below to calculate the projection distance. Aspect ratio 4:3 ET-DLE100 minimum maximum L (m) = (diagonal screen size in inches) x 27.6 - 45 L (m) = (diagonal screen size in inches) x 37.2 - 48 ET-DLE150 minimum maximum L (m) = (diagonal screen size in inches) x 28.0 - 54.0 L (m) = (diagonal screen size in inches) x 37.2 - 49.
S P E C F I L E PT-D5700/D5700L DLP ™ Projectors Shift range Optical axis shift function allows to shift the position of a projected image as shown. • Floor mount • Ceiling mount V (Height of projected image) Standard postition of projected image 0.5V 0.1H 0.5V 0.1H V (Width of projected image) (Height of projected image) H 0.1H Standard postition of projected image 0.1H H (Width of projected image) Installable angle Install the projector at an angle within the range shown below.
S P E C F I L E PT-D5700/D5700L DLP ™ Projectors List of compatible signals This projector supports RGB signals with horizontal frequencies of 15 to 91 kHz, vertical frequencies of 50 to 85 Hz and up to 150 MHz dot clock. NOTE: The native resolution of this projector is 1,024 x 768 pixels. If the display resolution of the input signal is different from the native resolution, image compression or expansion will be used to convert the input signal to a level within the native resolution.
S P E F C I L E PT-D5700/D5700L DLP ™ Projectors Serial connector The serial connector complies with RS-232C. To control the projector from a personal computer, commands must be input through communication software, based on the format and satisfying the communication conditions shown below. Pin assignments and signal names No. Signal name Description 1 – NC No.
S P E C F I L E PT-D5700/D5700L DLP ™ Projectors Cable specifications Projector 1 PC (DTE) NC NC 2 2 3 3 4 NC NC NC NC 6 7 7 8 8 9 4 5 5 6 1 NC NC 9 Control commands Item Command : Parameter Function Callback POWER PON * 1 POF * 1 OFZ:0 OFZ:1 OAS OSH :0 * 1/* 2 OSH :1 * 1/* 2 IIS:RG1 IIS:RG2 IIS:VID IIS:SVD IIS:DVI OTS:00 OTS:01 OTS:02 OTS:03 OTS:05 OTS:07 OTS08 OOS:0 OOS:1 Power on Standby power off Freeze off Freeze on Auto setup Shutter off Shutter on RGB 1 RGB 2 Vid
S P E C F I L E PT-D5700/D5700L DLP ™ Projectors Status asking commands Item POWER CONDITION Command : Parameter QPW Function Main power status FREEZE QFZ Freeze function status SHUTTER QSH Shutter function status INPUT SIGNAL QIN Input signal status TEST QTS Test pattern status ON SCREEN QOS On-screen display status PICTURE MODE QPM Picture mode status SYSTEM DAYLIGHT VIEW QVX:DLVI0 System daylight view status COLOR TINT COLOR TEMP.
S P E F C I L E PT-D5700/D5700L DLP ™ Projectors Parameter format Parameter format Size (Byte) 3 (1 or 2 bytes also possible when under control) 1 3 1 3 3 4 1 1 4 2 9
S P E C F I L E PT-D5700/D5700L DLP ™ Projectors Notes on Projector Placement and Operation The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the following precautions. 1. Never place objects on top of the projector while it is operating. 2. Make sure there is an unobstructed space of 500 mm or more around the projector’s exhaust openings. 3. Do not stack projector units directly on top of one another.