Owner's Manual

Recording
- 100 -
Applicable modes:
For details on [Rec] Mode menu settings, refer to P48.
Contrast and exposure will be adjusted automatically when there is a big difference in
brightness between the background and subject, to bring the image close to real life.
[ ] ([On])/[ ] ([Off])
Note
•
Even when the [Sensitivity] is set to [ISO100], [Sensitivity] may be set higher than [ISO100] if
the picture is taken with [i.Exposure] set to valid.
• Compensation effect may not be achieved depending on the conditions.
• [ ] in the screen turns to yellow when [i.Exposure] is in effect.
• This setting is not available for 3D recording.
Applicable modes:
For details on [Rec] Mode menu settings, refer to P48.
You can take bright pictures in dark places by setting [Min. Shtr Speed] slower. Also, you
can set it faster to reduce the blur of the subject.
[ ] ([Auto]), [ ] ([1/125]), [ ] ([1/60]), [ ] ([1/30]), [ ] ([1/15]),
[ ] ([1/8]), [ ] ([1/4]), [ ] ([1/2]), [ ] ([1])
Note
•
This should usually be set to [Auto] to take pictures. (When you select a minimum shutter
speed other than [Auto], [ ] appears on the screen.)
• When [Auto] is selected, shutter speed may be set up to 1 second when there is not much jitter
to adjust with the [Stabilizer], or when [Stabilizer] is set to [Off].
• Setting [Min. Shtr Speed] to slower speed might increase the chance of jitter, so we
recommend using a tripod and the self-timer for taking pictures.
• Setting [Min. Shtr Speed] to faster speed might make the picture darker, so we recommend
recording the picture in a well-lit area. If correct exposure cannot be achieved, [ ] will flash in
red when the shutter button is pressed halfway.
• For 3D recording, the setting is fixed to [Auto].
[i.Exposure]
[Min. Shtr Speed]
Minimum shutter speed setting 1/125 1
Brightness Darker Brighter
Jitter Less More
DMC-3D1PDF-VQT3U43_mst.book 100 ページ ２０１１年１０月２４日 月曜日 午後１時９分