Operating Instructions
Others
50
SQT0437 (ENG)
How to remove the battery
When disposing of the used product, perform [Factory data reset] to completely erase all data.
≥ Disassemble after the battery runs out.
≥ Wearing gloves is recommended during disassembly to prevent injury.
≥ If it cannot be removed smoothly, contact the dealer or Panasonic.
≥ Keep disassembled parts out of reach of children.
≥ Regarding the handling of used batteries
– Insulate the terminals with cellophane tape or similar.
– Do not disassemble.
This figure describes the disposal of this unit, it is not instruction for repair. If
disassembled, repair is not possible.
1 Use a suction cap (commercially
available) to lift up the LCD panel,
and insert a thin object such as a
card between the panel and the unit
to remove the LCD panel.
2 Remove all screws (6) in the image
below.
≥ Use a cross-slot screwdriver
(commercially available).
3 Remove the case.
4 Remove the screws (3), cover and
flexible board connectors (2), and
remove the lens tube module A.
5
Remove the flexible board connectors
(3), and remove the board
B
.
6 Insert a flathead screwdriver
(commercially available) into the
slot antenna holder C, lift up the
antenna holder D and remove it,
and then remove the battery.
DMC-CM1EB-SQT0437_mst.book 50 ページ 2014年10月22日 水曜日 午後3時30分