User Manual , Advanced

10. Using the Wi-Fi function

274

A picture can be automatically sent to a specified device every time you take it.

• When connected with [Send Images While Recording], [ ] is

displayed on the recording screen, and [ ] is displayed while

sending a file.

• To terminate the connection, follow the steps below:

> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [Yes]

• You can terminate the connection or change the send settings

by pressing [Wi-Fi]. (P261)

You cannot change the settings while sending pictures. Wait until sending is complete.

Images can be selected and sent after recording.

∫ How to select an image(s) after selecting [Single Select] or [Multi Select]

Send Images While Recording

• Since the camera gives priority to recording, sending may take longer during the recording.

• If you turn off this unit or the Wi-Fi connection before sending is complete, unsent pictures will

not be resent.

• You may not be able to delete files or use the playback menu while sending.

Not available in these cases:

• You cannot send motion pictures, 4K burst files and images recorded with the Post Focus

function.

Send Images Stored in the Camera

[Single Select] setting

1 Select the picture.

2 Select [Set].

[Multi Select] setting

1 Select the picture. (repeat)

• The setting is canceled when the picture is selected

again.

2 Select [OK].

• The number of pictures that can be sent by [Multi Select]

is limited.

• To change the send settings on a screen that is displayed after the image has been sent,

press [DISP.]. To terminate the connection, select [Exit].

6HW