Operating instructions

Connecting to other equipment
82
VQT1C14
• The drive is displayed as [NO_NAME] or
[Untitled] when you connect the camera
with a card inserted.
∫
About motion picture playback on a PC
Use the software “QuickTime”
(for Windows 2000/XP) in the CD-ROM
(supplied) to play back motion pictures
recorded on this camera on a PC.
• If you use “Windows 98/98SE/Me”,
download “QuickTime 6.5.2 for PC” from
the following site, and install it.
http://www.apple.com/support/quicktime/
• This software is installed as standard on a
“Macintosh OS”.
∫ Folder Composition
Folders are displayed as shown in the
following illustration.
1 Folder number
2 File number
3 JPG: pictures
MOV: motion pictures
MISC: Folder containing files on which the
DPOF print settings are recorded
• The data for up to 999 pictures recorded
by the camera can be included in 1 folder.
If the number of pictures exceeds 999,
another folder is created.
• To reset the file number or the folder
number, select [NO.RESET] in the
[SETUP] menu. (P20)
∫ Conditions under which a different
folder number is used
In the following cases, the picture is not
recorded in the same folder as the
previously recorded picture. It is recorded
in a folder with a new number.
1 When the folder just recorded to contains
a picture file with the number 999 in it
(example: P1000999.JPG).
2 When the card just recorded to contains,
for example, a folder with the number
100 [100_PANA] in it and that card is
removed and replaced with a card that
has a folder with the number 100 in it
recorded by a camera from a different
maker (100XXXXX, with XXXXX being
the name of the maker) and then a
picture is recorded.
3 When recording after selecting
[NO.RESET] (P20) from the [SETUP]
menu. (Pictures will be recorded to a
new folder with a number sequential to
the folder recorded to immediately
before. By using [NO.RESET] on a card
that does not contain folders or pictures,
such as one just formatted, the folder
number can be reset to 100.)
∫ About the PTP conection
If the OS is “Windows XP” or “Mac OS X”,
you can connect in PTP mode if you set
this unit to [ ] mode and then connect to
your PC.
• Pictures can only be read on the camera.
They cannot be written to a card or
deleted.
• When there are 1000 or more pictures on
a card, the pictures may not be imported.
• Do not use any other USB connection
cables except the supplied one.
• Do not disconnect the USB connection
cable while [ACCESS] is displayed.
• If there are a lot of pictures on the built-in
memory or a card, it may take time to
transfer them.
100_PANA
101_PANA
999_PANA
DCIM
MISC
P1000001.JPG
P1000002.JPG
P1000999.JPG
100_PANA
1
23
≥Built-in memory
≥
Card
VQT1C14ENG.book 82 ページ ２００６年１２月４日 月曜日 午後１１時０分