Operating Instructions

VQT2S42
142
Advanced (Recording pictures)
• Refer to P84 for details.
• Refer to P84 for details.
• Set to [ON] to display the [EXPO.METER] when correcting exposure,
performing programme shift, setting aperture, and setting shutter
speed.
• Unsuitable areas of the range are displayed in red.
• The exposure meter will only be displayed when the camera is set to
display information on the LCD monitor or viewfinder (P64)
• The [EXPO.METER] disappears after approximately
4 seconds if no operation is performed.
[AF+MF]
It is possible to adjust focus manually after it was adjusted
automatically.
[OFF]
[ON]: It is possible to finely adjust the focus manually by
rotating the focus ring while AF lock (Focus Mode is
set to [AFS] and shutter button is half-way pressed, or
AF lock with [AF/AE LOCK]).
[MF ASSIST]
In Manual Focus, the assistance screen appears on the screen to
facilitate focusing on the subject.
[OFF]
[ON]: Centre of the screen will be enlarged automatically
when the focus ring is rotated.
[MF GUIDE]
In Manual Focus, it is possible to check if the focus position is
near side or far side.
[OFF]
[ON]: MF guide is displayed on the screen when the focus
ring is rotated.
[PREVIEW HOLD]
This will set the operation of the [ ] button when displaying the
preview screen.
[OFF]: Preview screen is displayed only when the [ ] is
pressed.
It will return to previous screen when [ ] is released.
[ON]: Preview screen is displayed even after the [ ] is
released after pressing. (P100)
It will return to previous screen when [ ] is pressed
again.
[EXPO.METER]
Select whether or not to display the exposure meter when the mode dial is
switched to
³/±/´/² etc.
[OFF]/[ON]
DMC-G2K&G2W&G2EB-VQT2S42_eng.book 142 ページ ２０１０年４月１３日 火曜日 午後７時４０分