Operating Instructions

VQT2G56
168
Others
Using the AC Adaptor
You can use the camera without worrying about battery discharge when it is connected to
a PC or a printer if you use the DC cable
(DMW-DCC3; optional) to connect the camera to
the battery charger/AC adaptor and connect the AC mains lead.
• Check that the camera is turned off.
• Close the flash.
Connect the AC mains lead.
Connect the DC cable A.
• Pull open the DC cable cover 1 and then
connect the DC cable to the camera body using
the same steps as “Inserting and Removing the
Card (optional)/the Battery” (P26). Pull the DC
cable through the opening as shown in the
illustration and then close the battery door 2.
• Be careful not to catch the DC cable
(DMW-DCC3; optional) when closing the battery
door.
• You cannot charge the battery if you connect the
DC cable.
Note
• Do not use any other AC mains leads except the supplied one.
• Do not use any other cables except a genuine Panasonic DC cable (DMW-DCC3; optional). If
you use other DC cables, it may cause a malfunction.
• The camera becomes warm during use. This is not a malfunction.
• Disconnect the charger/AC adaptor and DC cable when the camera is not in use.
• It is recommended to use a fully charged battery or AC adaptor when recording motion
pictures.
• If while recording motion pictures using the AC adaptor the power supply is cut off due to a
power cut or if the AC adaptor is disconnected etc., the motion picture being recorded will not
be recorded.
• The unit is in the standby condition when the AC adaptor is connected. The primary circuit is
always “live” as long as the AC adaptor is connected to an electrical outlet.
DMC-GF1EB-VQT2G56_eng.book 168 ページ ２００９年８月２５日 火曜日 午後６時５９分