Operating Instructions

106
Edit and output of AVCHD Lite motion picture Setting the AVCHD Lite function
J [DVD-Video] panel
Setting regarding the MPEG2 conversion when recording
in DVD-Video format can be set.
z Quality setting of the conversion
A.It will convert with picture quality priority to prevent
the noise. It may take a long time to convert.
• It is recommended to use this setting when
converting a fast moving motion picture.
B.It will convert with standard quality.
C.It will convert with minimal time. More noise tends to
occur for fast moving motion picture.
J [AVCHD Lite] panel
Settings regarding AVCHD Lite motion picture can be set.
z Setting the playback method
Playback method when playing back can be selected.
A.It will playback in optimal speed.
B.It will playback in specified frame rate.
• Normally set to A, and when the playback fails, set to
B and select lower frame rate than current settings . (It
may improve.)
• The frames may skip or it may not playback smoothly
when a higher frame rate than the current setting is
selected.
z Auto protect setting for DVD writing
C.Auto protect is enabled and the protect setting will be
temporarily turned off when recording in AVCHD
standard to a DVD that is set as protected by the
AVCHD standard. (Protect setting is set again when
the DVD is ejected.)
• It will set protected after the recording even for the
DVD that is not set protected right after the formatting.
D.Auto protect is disabled, and recording to the
protected DVD is not possible.
 The DVD-RAM/RW that was recorded with auto protect
enabled is set as protected, so it may not be possible to format
by other DVD recording software or Explorer.
In this case, formatting the disc with this software will cancel
the protect setting, and enable other software to format the
disc. ([Complete erasure] will take a long time, so it is
recommended to use [Simple erasure].)
A
B
C
A
B
C
D