Operating Instructions

34
SQT0099
If the service number remains displayed despite
doing the above, request service from the dealer.
Inform the dealer of the service number when
requesting service.
START
¾ The system is being restarted during the
firmware update. Please do not turn off the
unit.
UPD/
(“  ” stands for a number.)
¾ The firmware is being updated.
Please do not turn off the unit.
FIN
¾ The firmware update is complete.
[For[South[East[Asia]
¾ Copying is complete.
Messages on the unit’s
display
NET
¾ While connecting to a network.
No PLAY
¾ There is a viewing restriction on a BD-Video
or DVD-Video. (> 29)
¾ The media is dirty or badly scratched. The
unit cannot play.
REMOVE
¾ The USB device is drawing too much power.
Remove the USB device.
SET 
(“  ” stands for a number.)
¾ The remote control and this unit are using
different codes. Change the code on the
remote control.
Press and hold [OK] and
the indicated number
button at the same time
for more than 5 seconds.
U59
¾ Temperature of this unit is hot and the unit
switches to standby for safety reasons.
Wait for about 30 minutes.
Install or place this unit with good ventilation.
H or F
(“  ” stands for a number.)
¾ There is something unusual.
¾ Check the unit using the troubleshooting
guide. If the service number remains
displayed, do the following.
1 Disconnect the plug from the household
mains socket, wait a few seconds, then
reconnect it.
2 Press [Í/I] to turn the unit on.
DMP-BDT460&360_EBGNGA-SQT0099.book 34 ページ ２０１４年１月２８日 火曜日 午後３時５７分