Operation Manual

Troubleshooting
SQT0807
110
Troubleshooting guide
The following messages or service numbers
appear on the front panel display when something
unusual is detected.
CAM is being updated. (> 100)
Selected titles in the USB HDD are being
converted.
Do not disconnect the USB HDD from this unit.
TV Guide data is being downloaded.
If there is no change after switching the unit to
standby mode and turning it on, consult the
dealer.
You cannot delete items on this disc.
The disc may be damaged.
• The disc is dirty. (> 10) The unit cannot record,
play, or edit.
• The lens cleaner has finished cleaning.
Press [< OPEN/CLOSE] on the main unit to
eject the disc.
You cannot write to this disc.
The disc may be damaged. Use a new disc.
• Displayed when the unit is started and is
switched to standby mode.
• There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. Wait until the
message disappears.
There are already 32 timer programmes. Delete
unnecessary timer programmes. (> 39)
The USB device is drawing too much power.
Remove the USB device.
The remote control and main unit are using
different codes. Change the code on the remote
control. (> 104)
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. (> 100)
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (> 100)
The media is not supported.
Messages on the front panel display
CAM Upgrade
Conversion
Guide
Hard Error
No Erase
No Read
No Write
Please wait.
Programme Full
Remove
Set Code 
(“∑” stands for a number.)
Start
SW-DL
Unsupport
DMR-BST_BCT855EG_eng.book 110 ページ ２０１５年６月４日 木曜日 午後２時５８分