Manual

e, rg"-J$1 •
O, REC
STATUS
(_ Available recording time
Recording mode
DVD-RAM
!
Counter
The time remaining until recording finishes changes each
time you press the button.
[]
STATUS
Shows recording
will stop in
30 minutes
Recording te!evislon programs
• Re-inserting double-sided discs
Reverse
You can get up to 12 hours
recording when you use
double-sided discs and use
the "EP" mode.
Turn over
• To check the remaining time and the current
mode during recording []
Press [STATUS] several times.
For your reference
• You can record up to 99 programs on one disc.
• You cannot change the channel or recording mode during record-
ing. You can change them while recording is paused, butthe mate-
rial is recorded as a separate program.
oAn error message appears it you try to start recording when a disc
is full; the remaining time will be shown as "0:00". To continue re-
cording, erase unneeded programs (DVD-RAM only .o page 58,
Erasing programs) or use another disc.
• There are limitations when recording to DVD-R (-- page 7).
oThe message "Could not write to disc." is displayed when record-
ing was not completed correctly. Check the discs for dirt or
scratches.
This is a simple way of timer recording when you are in a hurry or
before you go to bed. You can set the time up to 4 hours in advance.
While recording
Press [O, REC] to select the recording
time.
The time increases as illustrated each time you press the button.
After selecting the time the display updates indicating the time re-
maining until the unit stops recording. You can change the time
again with the same operation.
When the time you set is reached, recording stops and the unit
switches to standby.
• To cancel
During recording, press [O, REC] until the counter appears.
• Recording continues,
• To show the time remaining until recording fin-
ishes []
Press[STATUS].
For your reference
• This does not work during timer recordings.
• Recording stops and the set time is cleared it you press
[I STOP].
oThe set time is cleared if you pause recording and cause another
program to be recorded (for example, change the recording mode
or channel).
I