DVR User Manual

35
Timer recording (continued)
To check programmes
[RAM] [DVD-R]
Press [PROG/CHECK] (13).
The Timer Programme List screen appears.
Icon explanations (A)
¥ This programme is currently recording.
W The programme is overlap with another programme.
F The disc was full or the maximum number of programmes or
scenes was reached so the programme failed to record.
The television programme was copy-guarded so the
programme failed to record.
X The programme failed to record for some other reason.
Disc space
OK: Displayed if the recording can fit in the remaining
space on the disc. However, when the programme
becomes longer than scheduled during the
recording by setting “PDC” to “ON”, the
programme may not be recorded until its end.
# (Date): For recordings made daily or weekly, the display
will show until when recordings can be made
based on the time remaining on the disc.
!: Displayed if the disc is not inserted in the unit or is
write-protected (pages 38, 73) or there is not
enough memory capacity left on the disc.
ªTo change the programme
(page 34)
ªTo exit from the Timer Programme List screen
Press [PROG/CHECK] (13) or [RETURN] (23). (The television is
shown.)
For your reference
Programmes that failed to record are deleted from the list at 4
a.m. the day after tomorrow.
Starting and canceling programmes
[RAM] [DVD-R]
ªTo put the unit on recording standby
Press [ , TIMER] (12).
The unit turns off and lights on the unit’s display.
Note
The unit cannot go to timer recording standby if the disc is
protected (pages 38, 73) or full (“ ” flashes). Check the disc
carefully.
ªTo release the unit from recording standby
If you want to record something else before the programme start
time, for example:
Press [ , TIMER] (12).
The unit turns on and “ ” goes out.
Be sure to press [ , TIMER] (12) before the programme start
time to put the unit on recording standby. The programme only
works if “ ” is on.
ªTo stop recording while a programme is working
Press [ , TIMER] (12).
To clear a timer recording programme
[RAM] [DVD-R]
Press [CANCEL] (5) or [ERASE] (30) while the
programme’s Timer Programme Correction screen is
being shown.
(Alternatively, use [3, 4] (10) to select the programme
in the Timer Programme List screen and press
[CANCEL] (5) or [ERASE] (30).)
You can not delete programmes that are currently recording.
RETURN
SELECT
SP
OK
1:221:19
BBC 1
16/ 7 TUE01
Mode
Disc
space
StopStartNo.
Name
Date
1:58 SP
TIMER
RECORDING
Remain
1:19:00 16.7 TUE
ENTER
CANCEL
OFF
PDC
New Timer Programme
W
F
X
02
03
04
05
BBC 1
BBC 1
BBC 1
BBC 1
16/ 7
TUE
24/ 7 WED
24/ 7 WED
24/ 7 WED
1:20
8:00
9:00
10:00
2:20
9:00
10:00
11:00
SP
SP
SP
SP
OFF
OFF
OFF
OFF
OK
OK
OK
OK
A
B.book 35 ページ 2003年2月4日 火曜日 午後2時50分