Manual

Youcanenterupto32programsuptoamonthinadvance.
Eachdailyorweeklyprogramiscountedasoneprogram.
1 Press [PROG/CHECK].
A line that is
ready for
programming
is highlighted.
2 Press [ENTER].
3
Press [1_] to move through the items
and change the items with [A, T].
• The current settings are shown each time you press [1_].
• You may use the numbered buttons to enter the CHANNEL,
DATE, ON (start Time), and OFF (Finish Time).
• CHANNEL (Channel number and caption)
• DATE
Current date
_ u n da
Next day up to one month later rain a o e y
WJe_y timer: SUN-SAT_MON-SAT_MON-FRI
Djly'timer: WEEKLY SUN ..... WEEKLY SAT
• ON (Start time)/OFF (Finish time)
The time increases or decreases in 30-minute increments if
you hold the button.
• MODE (Recording mode _page 15)
SP_XP_FR_EP_LP (_Return to SP)
•DRIVE
HDD_DVD
•RENEW
(Only when you set daily or weekly recording onto HDD
_page 26, Auto Renewal Recording)
ON--OFF
• Enter Title
Select "Enter Title" using [_1, I_] and press [ENTER]
(")page 38).
4 Press [ENTER] when you have
finished programming the timer.
5
Displayed if the
recording can fit
-- in the remaining
space on the
disc,
• Press [A, Y] to select "New Timer Program" and repeat
steps 2- 4 to program other recordings.
Press [PROG/CHECK] or [RETURN].
The timer recording list disappears and the unit enters Timer
Recording standby mode ("_" appears on the unit display),
• The unit is not off. To save power, turn the unit off by press-
ing [_, DVD POWER].
To release the unit from recording standby
Cancel all the timer recording programs using [CANCEL]
(,,_page27),
To stop recording when recording has already
begun
Press [m], then [ENTER] within 5 seconds.
Recording stops.
[Note] ...............................................................................
• When the program timer reaches the set time when in record-
ing standby mode, timer recording will start even if the unit is
playing or recording another program.
• The actual time recorded may be longer than the program itself
when television programs are recorded using VCR Plus+.
• If you don't select a recording mode when using VCR Plus+
codes to make a timer recording, the unit sets the mode
selected on the unit at that time (unless the mode is "XP", in
which case the unit sets "FR" as the mode).
• "All timer programs are occupied:' appears if there are
already 32 programs.
• The remaining time displayed is based on the current record-
ing mode.
• When you program successive timer recordings to start
immediately one after the other, the unit cannot record the
part at the beginning of the later programs (a few seconds
when recording with HDD or DVD-RAM, and approximately
30 seconds when recording with DVD-R).
• If you set DST (Daylight Saving Time) to ON when manually
setting the clock (-I, page 47), timer recording may not work
when summer switches to winter and vice versa.
• "(_" flashes when the unit couldn't go to timer recording
standby.
• When timer recording starts, the record lamp (.._page 13,
Main unit) lights, even if the unit is off.
8
RQT6984