Manual

Preparation
• Confirm that the antenna is connected correctly.
• Turn on the television and select the appropriate video input to
suit the connections to this unit.
1 Press [_, DVD POWER] to turn the
unit on.
2
Press [A, V] to select "Channel" and
press [1_].
3 Press [A, V] to select "Antenna Sys-
tem" and press [ENTER].
2
Press [_, Y] to select the menu lan-
guage and press [ENTER].
e.g., when you select
English
4
5
Press [A, T] to select "TV" or
"CAW" and press [ENTER].
The screen shown in step 2 reappears.
Press [A, T] to select "Auto Channel
Setting" and press [ENTER].
3
4
Press [ENTER].
Plug-in Auto Tuning starts and the unit puts the stations it
can receive into channels.
The unit then proceeds with Auto Clock Setting. The time is
displayed when finished, if the clock is an hour slower or
faster than the actual time, go to "Time Zone Adjust" to cor-
rect it (..,)page 47).
When the display shows the correct time
Press [ENTER] to complete Plug-in
Auto Tuning.
If the unit couldn't set the clock automatically
Press[ENTER] to show the "Manual Clock Setting" screen. Set the
time manually (,,,)page47).
To start Plug-in Auto Tuning again (after reloca-
tion, for example)
Antenna system, channel caption, and VCR Plus+ guide
channel settings all revert to the default values when you
perform the procedure below. Timer recording settings are
also cleared.
When the unit is on and stopped
O Press and hold [v, CH] and [^, CH] on the main unit for
about five seconds.
The unit turns off.
@ Press [_, DVD POWER] to turn the unit on,
Follow the above steps 2_4.
1 Press [SETUP] to showthe menus.
6
If you have not yet set clock, the "Auto Channel/Clock Set-
ting" screen appears.
Press [ENTER].
Auto setting starts. This takes a few minutes. (To stop auto
channel setting, press [RETURN].) When finished, the Com-
plete screen or time display is shown. Press [ENTER].
To return to the previous screen
Press[RETURN],
When you are finished
Press[SETUP].
Add or delete channels if necessary channels are not set or unnec-
essary channels are set.
While this unit is receiving the antenna signal (but not during
recording):
1 Press the numbered buttons to select
a channel.
e.g., "5": [0] "_ [5] Unit's display
"f5": [1] _ [5]
"115": [100] -_ [1] -) [5]
='You can etso use [^, v, CH1
when you ere going to delete a channel.
2 Press [ADD/DLT].
The channel is deleted if itwas set or added if it was not set.
e.g.,
Repeat steps 1 and 2 as necessary.