Operating Instructions

Getting started
SQT0807
13
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right
way up.
Main unit
1 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
2 Open/close disc tray
3 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
4 CI module eject button (> 14)
5 CI slot (> 14)
6 Disc tray
7 USB port
8 SD card slot
• When removing the SD card, press on the
centre of the card and pull it straight out.
 

Display
Pull to flip down the
front panel.

 
SD card
USB memory
Disc
Display
1 Main display section indicator
• Messages and other information are
displayed. (> 110)
2 Drive (HDD, BD or SD) indicator
3 Recording indicator
• The indicator will light up while recording.
• The indicator will blink while recording is
paused and before recording starts.
4 Playback indicator
5 SD card slot indicator
6 USB port indicator
7 Disc indicator
8 Copying indicator
9 Remote control signal indicator
10 Timer recording indicator
This indicator lights up when the timer
recording standby or Keyword Recording
standby
§
is activated.
§
[BCT85 5] [BCT850] [BST855] [BST850] only
23
8109
56
7
4
1
DMR-BST_BCT855EG_eng.book 13 ページ ２０１５年６月４日 木曜日 午後２時５８分