Operating Instructions - Language - English
∫ Advanced Operations
50
First of all, please disconnect AC mains leads of all units which you are going to connect with before connecting and disconnecting
cables.
ªEnjoying more powerful sound
Refer to the relevant pages for details.
ªOther uses
Record to digital recording equipment or cassette deck (See below [A] [B])
Record from a video cassette recorder (page 51)
Use connection [B] to enjoy discs recorded with a sampling frequency of 96 kHz. (page 52)
Note
You can enjoy Dolby Digital in stereo with this unit alone. (This unit does not have a DTS decoder.)
[DVD-A]
Even if using this connection, output will be only 2 channels.
(1) Rear panel of this unit
(2) Insert fully, with this side
facing up. (Do not bend when
connecting.)
(3) Optical digital audio cable (not
supplied)
(4) To optical digital input
(5) Amplifier or system
component (with or without
decoders) (not supplied)
(6) Speakers (not supplied)
≥Example: 6 speakers
For your reference
≥The DTS decoder must be
compatible with the signals
recorded on DVD.
≥During Quick View, the Digital
Audio Output will change to
PCM Output.
(1) Rear panel of this unit
(2) To AUDIO OUT (L/R)
(3) Audio cable (not supplied)
A Red (R)
B White (L)
(4) Audio input (L/R)
(5) 2-channel analog amplifier or system component
(not supplied)
Upgrading your system
Enjoying 5.1-channel surround
sound with Dolby Digital and DTS
Digital connection
Connect to an amplifier with
built-in decoders.
See below
[A]
SET UP—Sound
≥Set “PCM Down Conversion” to “On”.
≥Set “Dolby Digital” and “DTS” to suit
the equipment.
Page 54
Change speaker settings on the
amplifier.
—
To enjoy stereo
Analog connection
Connect to an analog amplifier
or system component.
See below
[B]
SET UP—Sound
≥Set “PCM Down Conversion” to “Off”. Page 54
Digital connection
Connect to a digital amplifier or
system component.
See below
[A]
SET UP—Sound
≥Set “PCM Down Conversion” to “On”.
≥Set “Dolby Digital” to “PCM”.
≥Set “DTS” to “Off”.
Page 54
Connecting a digital amplifier or
system component [A]
You can record the digital signal directly onto digital recording
equipment.
The signals on DVDs will be converted to 48 kHz/16 bit linear
PCM.
When recording DVDs, ensure the following conditions are met.
≥There is no copy guard recorded on the disc.
≥The recording equipment can handle a sampling frequency of
48 kHz/16 bit.
≥You cannot record MP3.
OPTICAL
DIGITAL AUDIO OUT
(PCM/BIT STREAM)
R - AUDIO
R - AUDIO
IN
~
(1)
(3)
(4)
(5)
(6)
(2)
Connecting an analog amplifier or
system component [B]
OPTICAL
DIGITAL AUDIO OUT
(PCM/BIT STREAM)
R - AUDIO - L VIDEO S-VIDEO
(L1)
R - AUDIO - L VIDEO S-VIDEO
(L3)
IN2IN1
(2)
(3)
(1)
(4)
(5)
DVD(PAL).book50ページ２００３年１０月９日 木曜日 午前１１時３２分