Operating Instructions

78
RQT9193
Troubleshooting guide
Operation Page
Cannot operate the television.
The remote control doesn’t
work.
Change the manufacturer code. Some televisions cannot be operated even if you change the
code.
The remote control and main unit are using different codes. Change the code on the remote
control.
Press and hold [OK] and the indicated number button at the same time
for more than 5 seconds.
The batteries are depleted. Replace them with new ones.
You are not pointing the remote control at the main unit’s remote control signal sensor during
operation.
Coloured glass may obstruct the signal reception/transmission.
Don’t place the signal sensor in direct sunlight or in areas that may be subject to sunlight
exposure.
It may be necessary to set the code on the remote control again after changing the batteries.
It may be necessary to set the manufacturer code again after changing the batteries.
The child lock function is activated.
68
66
2
2
66
68
68
The unit is on but cannot be
operated.
Recording drive or playback drive has not been selected properly.
Some operations may be prohibited by the disc.
The unit is hot (“U59” appears on the display). Wait for “U59” to disappear.
One of the unit’s safety devices may have been activated.
Reset the unit as follows:
1Press [Í/I] on the main unit to switch the unit to standby.
If the unit doesn’t switch to standby, press and hold [Í/I] on the main unit for about
10 seconds. The unit is forcibly switched to standby.
Alternatively, disconnect the AC mains lead, wait one minute, then reconnect it.
2 Press [Í/I] on the main unit to switch it on. If the unit still cannot be operated, consult the
dealer.
17, 18
Cannot eject disc. The unit is recording.
Linked timer recordings with external equipment is in recording standby (“EXT-L” on the
units display blinks when [Í DVD] is pressed). Press [EXT LINK] to cancel the recording
standby.
The unit may have a problem. While the unit is off, press and hold [] and [CH W] on the
main unit at the same time for about 5 seconds. Remove the disc and consult the dealer.
If the Child Lock function is activated, above operation does not work. Cancel the Child Lock
function.
24
68
Startup is slow. Make sure that “Quick Start” is set to “On”.
Startup takes time in the following situations:
A disc other than a DVD-RAM is inserted.
The clock is not set.
Immediately after a power failure or the AC mains lead is connected.
When the unit is connected with an HDMI cable.
67
DMR-EX81SEG_RQT9193.book 78 ページ 2008年7月28日 月曜日 午後5時29分