Operating Instructions

18
RQT9118
Recording Television Programmes
Refer to “Important Notes for Recording” (➔ 21) and “Advanced Recording” (➔ 22 to 24) for detail information on
recording.
RAM
-R -R DL -RW(V) +R +R DL +RW
Preparation:
Turn on the television and select the appropriate video input to suit the
connections to this unit.
RAM
If the disc is protected, release protection (➔ 48).
•
•
to turn the unit on.
to open the tray (Button located on front of the unit).
Insert a disc with enough remaining blank space and press
[
;
OPEN/CLOSE] again to close the tray.
When the format confirmation screen is displayed (➔ 23)
–
–
to select desired channel.
To select with the numbered buttons (➔ 16)
When no channel setting is performed on the unit and broadcast is
recorded directly from the satellite receiver, select a channel on the
connected equipment and press [INPUT SELECT] to select “AV2”.
–
–
to select the recording mode.
Recording mode (➔ 22)
Remaining time
to start recording.
Elapsed recording time
Pausing Recording
Press [
h
PAUSE].
– Press again to restart recording.
(The title is not divided.)
Stopping Recording
Press [
g
STOP].
Tips
RAM
-RW(V) +R +R DL +RW
To use a new disc, formatting is
necessary.
Notes
-R -R DL -RW(V) +R +R DL +RW
It takes about 30 seconds for the unit
to complete recording management
information after recording finishes.
You cannot change the channel or
recording mode during recording.
This unit cannot record NTSC signals
to discs that already have PAL signal
recordings.
•
•
•
DMR-EZ28-EB _RQT9118-B.indb 18DMR-EZ28-EB _RQT9118-B.indb 18 2008/04/04 10:31:542008/04/04 10:31:54