Operating Instructions

Getting started
VQT4W80
22
Settings
7 Select “Start Auto Setup”, then press [OK].
To set Quick Start settings
1 Press [FUNCTION MENU].
2 Select “Basic Settings” in “Setup”, then press
[OK].
3 Select “Standby Settings” in “Others”, then
press [OK].
4 Select “Quick Start”, then press [OK].
5 Refer to page 19, step 5.
To start Easy Network Setting
1 Press [FUNCTION MENU].
2 Select “Basic Settings” in “Setup”, then press
[OK].
3 Select “Easy Network Setting” in “Network”,
then press [OK].
4 Refer to page 20.
To confirm that channels have been tuned
correctly
Refer to “Using Channel List”. (> 25)
6 Make the settings of user band.
• User Band
You can set C1 to C8. Set to a User Band
not used by any other device.
• When only one User Band of the Router
is assigned, set “Tuner 2” to “Off”. Note
that you will not be able to record two
programmes simultaneously or watch TV
during recording.
• User Band Frequency
Set the User Band Frequency with number
buttons.
• User Band PIN
If the single cable router requires a PIN to
access an user band, enter the PIN.
• For details, read the manual of the single
cable router, etc.
User Band Settings
OK
Select
RETURN
Start Auto Setup
Please confirm user band settings before starting Auto Setup.
Tuner 1
User Band
User Band Frequency
User Band PIN
Tuner 2
User Band
User Band Frequency
User Band PIN
C1
1284 MHz (preset: 1284 MHz)
Off
C2
1400 MHz (preset: 1400 MHz)
Off
8 Select the search mode, then press [OK].
Auto Setup starts.
These operations (Searching Satellite and
Searching Channels) may take some time.
After tuning has been completed, clock will
be set automatically.
If the clock setting screen appears, set the
time manually (> 85, Clock).
Auto Setup
RETURN
Satellite
Progress
This will take up to 40 minutes.
Checking LNB1
Satellite
Tuner 1 Tuner 2
Press RETURN to skip Satellite installation
Searching Satellite
Checking... Checking...
0%
100%
DMR-HST230_130EG_eng.book 22 ページ ２０１３年７月８日 月曜日 午後５時４５分