Operating Instructions

Reference
TQBS0037
103
Cannot play back.
• The disc is dirty. (> 26)
• The disc is scratched or marked.
• The disc may not be able to play back if it was
not finalised or a Top Menu was not created on
the equipment used for recording.
• Refer to “Screen icons”. (> 46)
• Depending on the encrypted service, it may not
be possible to play back certain programmes if
they have been recorded without being
decrypted.
• Depending on the Ultra HD Blu-ray disc, it may
not be possible to perform playback unless this
unit is connected to the Internet.
Audio and video momentarily pause.
• DVD-R DL and +R DL discs have two writable
layers on one side. Video and audio may
momentarily cut out when the unit is switching
layers.
Image for the Quick View is not smooth.
• Image may not be played back smoothly in case
of high definition contents.
Cannot play the disc on other players.
• Refer to “Play on other players”. (> 26)
Cannot edit.
• You may not be able to edit on the HDD if there
is no available space. Delete any unwanted
programmes to create empty space. (> 57)
Photos do not play back normally.
• The images that were edited on the PC, such as
Progressive JPEG, etc., may not play back.
(> 24)
This unit does not recognize the USB device
correctly.
• If inserted during playback the USB device may
not be recognized by this unit.
Disconnect and reconnect the USB device. If it
still does not recognize the connection, switch
the unit to standby mode and turn it on again.
• USB devices connected using a USB extension
cable other than a dedicated one or a USB hub
may not be recognized by this unit.
• Two USB devices cannot be used
simultaneously. If you insert a USB device while
watching TV, the USB device detection screen
is displayed. Use this screen to select the
device you want to use.
Play
You have forgotten your rating PIN.
• The rating level returns to the factory preset.
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• “00 RET” is displayed on the front panel
display.
2 Repeatedly press [1] (right) until “03 VL” is
displayed on the front panel display.
3 Press [OK].
• “Init” is displayed on the front panel display.
Edit
Photo
USB
DMR-UBC&UBS80EG_eng.book 103 ページ ２０１８年５月２８日 月曜日 午後３時１５分