Operating Instructions

Reference
TQBS0037
106
The following messages or service numbers
appear on the front panel display when something
unusual is detected.
CAM is being updated. (> 81)
The picture quality of the selected programme
stored in the USB HDD is being changed.
Do not disconnect the USB HDD from this unit.
TV Guide data is being downloaded.
You cannot delete items on this disc.
The disc may be damaged.
• The disc is dirty. (> 26) The unit cannot record,
play, or edit.
• The lens cleaner has finished cleaning.
Press [< OPEN/CLOSE] on the main unit to
eject the disc.
• Displayed when the unit is started and is
switched to standby mode.
• There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. Wait until the
message disappears.
• There are already 32 timer programmes. Delete
unnecessary timer programmes. (> 41)
• You are trying to divide a programme when the
maximum possible number of programmes is
already stored on the media.
The USB device is drawing too much power.
Remove the USB device.
The remote control and main unit are using
different codes. Change the code on the remote
control. (> 99)
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. (> 81)
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (> 81)
The media is not supported.
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. (> 81)
An error has occurred in the antenna’s power
supply. Check to see if the antenna’s cable core
and braided wire shield are in contact with each
other.
Messages on the front panel display
CAM UPGRADE
CONVERSION
GUIDE
NO ERASE
NO READ
PLEASE WAIT.
PROGRAMME FULL
REMOVE
SET CODE 
(“∑” stands for a number.)
START
SW-DL
UNSUPPORT
UPDATE /
(“∑” stands for a number.)
U50
DMR-UBC&UBS80EG_eng.book 106 ページ ２０１８年５月２８日 月曜日 午後３時１５分