Operating Instructions

Setup
TQBS0037
92
Digital Audio Output
PCM Down Conversion
Select how to output audio with a sampling
frequency of 96 kHz.
•On:
Signals are converted to 48 kHz.
(Choose when the connected equipment
cannot process signals with a sampling
frequency of 96 kHz.)
• Off:
Signals are output as 96 kHz.
- When the signals have a sampling
frequency of over 96 kHz.
• The signals will be converted to 48 kHz
regardless of the setting in the following
cases.
- When the disc has copy protection.
- When “BD-Video Secondary Audio” is
set to “On”. ([BD-V]) (> below)
Dolby D / Dolby D + / Dolby TrueHD
DTS / DTS-HD
MPEG
HE-AAC
Select the audio signal to output.
• Select “PCM” when the connected
equipment cannot decode the respective
audio format.
• Not making the proper settings may result in
noise.
System Volume Adjustment
If the volume of a programme being watched
through this unit is different than the volume
of a programme being watched directly on the
TV, the gap may be reduced by switching this
setting to Mode 1 or Mode 2. (This function
works only while you are watching a
programme or playing back a programme
recorded in DR mode with this unit.)
BD-Video Secondary Audio
Turn on/off the clicking sound on the menu
and audio with secondary video.
• To enjoy BD-Video that supports Dolby Atmos
R
or DTS:X
TM
Connect this unit to an AV amplifier or similar device that
supports it with an HDMI cable, and select the following
settings:
- Dolby D / Dolby D + / Dolby TrueHD: “Bitstream”
- DTS / DTS-HD: “Bitstream”
- BD-Video Secondary Audio: “Off”
Dolby Atmos is a trademark of Dolby Laboratories.
Audio Delay
Mis-sync between the video and audio is
corrected by delaying the audio output.
Display
Language
Select the language for on-screen menus.
On-Screen Information
Select the time until the channel information
screen (> 29) disappears automatically.
Front Panel Display
Changes the brightness of the front panel
display.
• If “Automatic” is selected, the display turns dark
during play and disappears when the unit is in
standby mode. While using this mode, the
standby power consumption can be reduced.
• When “Quick Start” is set to “Off” or “Timer
Setting for Quick Start” (> 97), this function is
fixed to “Automatic”.
Screen Saver
This is to prevent image retention on the screen.
Teletext
Select the Teletext (> 29) display mode.
DMR-UBC&UBS80EG_eng.book 92 ページ ２０１８年５月２８日 月曜日 午後３時１５分