Operating Instructions

SQT1378

Turning on the LED Light

Rotate the LED light output

control dial.

Rotating in the direction of 1:

Decreases the amount of light or turns

off the LED light.

≥ When you rotate the dial until it stops, the LED light turns

off.

Rotating in the direction of 2:

Increases the amount of light.

≥ The flash and batteries may become warm if you keep the

LED light on, but this is not a malfunction.

Wireless Flash Settings

Wireless control is available with Panasonic digital cameras

that support wireless mode. See the operating instructions

of the digital camera for operation of the digital camera

during wireless flash shooting.

1 Set the camera to wireless

mode.

2 Set the flash to [RC] mode.

“Flash Mode” (P9)

3 Rotate the flash head.

4 Set the channel with the

[CH] switch.

• Set the camera and flash to the

same channel.

5 Set the group with the [GR]

switch.

• The camera can adjust flash

settings separately for up to 3

groups; choose the group to which

the flash belongs.

≥ If it is difficult to slide the switch, use the tip of a ball point

pen or similar tool to slide it.

≥ After setting the channel and group, return the flash head

to its original angle.

The Firing mode, the flash adjustment, and the manual

flash adjustment can be set for each group by operating the

camera.

≥ The flash will operate as follows when you set the camera

to a setting not supported by the flash:

 

Camera Flash

[Firing Mode]: [AUTO] Does not fire.

[Wireless FP]: [ON] Fires as normal.

SQT1378_ENG.fm 10 ページ２０１６年４月２２日　金曜日　午後６時０分