Operating Instructions

SQT1378

Slave Mode

The flash can be fired remotely in sync with any flash fired

by other units.

1 Set the flash mode to

[SLAVE].

“Flash Mode” (P9)

2 Position the flash.

Flash positioning method is same

as the wireless mode.

“Placing Wireless Flash Units”

(P11)

Refer to the camera operating

instructions for details about the

flash positioning range.

• Set the flash mode of the camera to the manual which

does not fire the pre-flash. If the camera fires the pre-

flash, the external flash synchronizes with the pre-flash

of the camera, and cannot fire the flash light properly.

• The flash may fire in response to flash units used by

other photographers.

Cautions for Use

∫ About the unit

Do not carry the unit when it is still attached to the

camera body.

We recommend that you place the unit in the flash case

when carrying it.

≥ Place the unit in the flash case with the flash head side

up.

∫ About the batteries

Be sure to remove the batteries when you will not be

using the unit for a long period of time.

SQT1378_ENG.fm 12 ページ２０１６年４月２２日　金曜日　午後６時０分