Operating Instructions - Function Parameters

15
Chapter 2 General Settings
40-59 44 Data Deletion of
HD
Set the deletion security lev
el of hard disk
data in every copy/print job.
z When the optional hard disk unit is
installed, every copy/print job data is
automatically deleted after each job is
completed.
For higher security select Medium and
High, however, the deletion time increases
with the increase in security level, and may
take longer to erase the data.
Basic, Medium, High Basic
45 WINS Server 1 IP Set the IP address of WINS Server 1. 3 digits x 4 0. 0. 0. 0.
46 WINS Server 2 IP Set the IP address of WINS Server 2. 3 digits x 4 0. 0. 0. 0.
47 Scope ID Set the Net Bios Scope ID. Up to 223 characters
48 IP Filter Set the IP filter to provide security to
network function such as printer or
scanner.
Off, On Off
49 IP Filter Mode By setting “50 IP Filter Address”, allow
or deny the network function of registered
IP filter address.
Allow, Deny Allow
50 IP Filter Address Set the IP filter address.
Up to 4 addresses can be set.
z When setting only one IP filter address,
input the same IP address for both “Start
Address” and “End Address”.
3 digits x 4 0. 0. 0. 0.
51 Community Name
(1)
Set the SNMP community name (1). Up to 15 characters public
52 Community Name
(2)
Set the SNMP community name (2). Up to 15 characters public
54 SysContact Set the system management name. Up to 31 characters
55 SysName Set the system name. Up to 31 characters Panasonic
DP-C262/
322
56 SysLocation Set the system installation place. Up to 31 characters
59 SMB Set “On” when using the machine for
Microsoft Network (SMB).
Off, On Off
60-79 60 SMB Master
Browse
Set “On” when using SMB Master
Browse.
Off, On Off
61 SMB Device
Name
Set the device name for Microsoft
Network (SMB).
Up to 15 characters
62 SMB Workgroup
Name
Set the working group name for Microsoft
Network (SMB).
Up to 15 characters
63 SMB Comment Set comments about the machine used
for Microsoft Network (SMB).
Up to 48 characters
No. 45 to 60
After setting, turn the machine’s power switch Off,
and then On again.
Key Operator
No. Parameter Comments Selective Item Standard
Setting