Operating Instructions

• Consult the manufacturer of any personal medical
devices, such as pacemakers or hearing aids, to
determine if they are adequately shielded from
external RF (radio frequency) energy. (The product
operates in the frequency range of 2.412 GHz to
2.472 GHz.)
• Do not use the product in health care facilities if any
regulations posted in the area instruct you not to do
so. Hospitals or health care facilities may be using
equipment that could be sensitive to external RF
energy.
1.1.2 CAUTION
Installation and relocation
• After moving the unit from cold areas to warmer
areas, wait approximately 30 minutes before turning
on the power switch to allow the unit to adjust to the
ambient temperature. If the power switch is turned on
too soon after a sudden climate change,
condensation may form inside the unit, causing
malfunction.
• Never turn the unit upside down or sideways when
moving it.
• Never install telephone wiring during a lightning storm
(fax supported models only).
• Never install telephone jacks in wet locations unless
the jack is specifically designed for wet locations (fax
supported models only).
• Never touch uninsulated telephone wires or terminals
unless the telephone line has been disconnected at
the network interface (fax supported models only).
• Use caution when installing or modifying telephone
lines (fax supported models only).
• Do not position the unit in a location where it is
unstable or subject to vibrations.
• Place the unit on a surface which is larger in area
than the bottom surface of the unit.
• To prevent the risk of the unit falling, ensure that the
legs or casters of the table, desk or stand are
positioned outside of the unit when placing the unit
on it.
Laser radiation
CLASS 1 LASER PRODUCT
• The printer of this unit utilises a laser. Use of controls
or adjustments or performance of procedures other
than those specified herein may result in hazardous
radiation exposure.
See the operating instructions for the Laser diodes
properties.
LED light
CLASS 1 LED PRODUCT
• When using the unit, do not look directly at the CIS’s
LED light. Direct eye exposure can cause eye
damage.
See the operating instructions where the CIS LED
specifications are listed.
Recording paper exit rollers and fuser unit
• During or immediately after printing, near the
recording paper exit roller shaft and fuser unit gets
hot. This is normal. Do not touch it.
Note
• The area near the rear cover may also get warm.
This is normal.
Toner cartridge
• Avoid ingestion, inhalation, eye or skin contact.
– If ingestion occurs, drink several glasses of water
to dilute stomach contents.
– If inhalation occurs, exit the area immediately into
an area with fresh air.
– If skin contact occurs, wash thoroughly with soap
and cold water, then air dry. Do not use hot water
or hair dryer.
– If eye contact occurs, flush thoroughly with water.
– In all cases, seek medical treatment if adverse
symptoms occur.
USB memory device (only models with a USB port)
• When you insert the USB memory device into the
USB port of the unit, take care not to damage the
device.
Explanation of graphical symbol on the equipment
: Alternating current.
: Caution, hot surface.
1.1.2 CAUTION
5