Manual

Preparing the remote
control
Power supply
Face (_) upwards.
i
• Replacing the button-type battery
The battery normally lasts for about a year.
Replace if the remote control fails to operate
the unit when used within the operation
range.
Refer to "IMPORTANT SAFETY
INSTRUCTIONS" on pages 6 and 7.
Remote control
signal sensor
About 7 m
(23 feet) in
front of the
signal sensor
• Do not expose the remote control signal
sensor to bright light.
e Do not place obstacles between the
remote control signal sensor and the
remote control.
_eDo not another unit's remote control at
use
RQT6025the same time.
Insulation sheet
Built-in battery
Leave the built-in battery attached when-
ever you use the unit.
You can power the unit in one of four ways.
eAC adaptor (see below)
eBuilt-in battery (= page 11)
eOptional car adaptor (=, page 34)
eOptional battery pack (= page 35)
This unit DC_CC IN 9 V e_C*-_
(Left side) 1
Household
AC outlet
(AC 120 V,
2 60 Hz)
3
Refer to "IMPORTANT SAFETY
INSTRUCTIONS" on page 6.
The unit is in the standby condition (the
[(b] indicator lights) when the AC power
supply cord is connected. The primary
circuit is always "live" as long as the
AC adaptor is connected to an electrical
outlet.
• When the unit is not going to be used
for a long time
The unit consumes 0.9 W when in standby
mode.
To conserve power, disconnect the AC
power supply cord from the AC outlet.