Operation Manual

40
The player does not respond
to function key commands:
The remote control unit does not work:
Playback does not start after
pressing PLAY:
Unable to change audio track
or subtitle languages:
The subtitles are not shown:
The language selected from the
menu is not used for the audio
track or subtitles:
Unable to change the aspect angle:
GENERAL PROBLEMS
!
!
Certain control operations are not available with some discs.
Interference caused by lightning or static charge. Press [ ] to put the player into stand-by mode.
Restart the player.
/I
!
!
Check if the batteries are in the right way round (+ and -).
Point the remote control unit straight at the remote control signal sensor on the front panel.
!
!
!
!
Condensation has accumulated inside the player. Wait for 1 to 2 hours.
The player only supports DVDs with regional code "2", "All" or from a group of regional codes
containing regional code "2".
The disc is dirty.
The disc is in the wrong way round. The label of the disc you wish to play must face up.
!
!
You can only choose from the languages actually recorded on the disc.
Some discs require you to change languages via the disc menu.
!
!
!
The disc does not provide any subtitles.
You deactivated the display of subtitles.
The subtitles are output to the wrong position. Move the position of subtitles.
!
The disc does not provide the language you selected.
!
It depends on the disc whether this function is available.
Before requesting service
!
Stop the player and keep pressing player button together with and OPEN/CLOSE until
"Initialized" disappears from the screen.
This will restore all factory defaults.
When you are done switch off the unit and back on afterwards.
You will afterwards have to go to the QUICK SETUP menu ( page 15-16 ) to set up the basic settings
again.
/
Have you forgotten your password?